- DL manuals
- Zanussi
- Hob
- ZGS 682 I
- Instruction Booklet
Zanussi ZGS 682 I Instruction Booklet
Summary of ZGS 682 I
Page 1
Zgs 682 ict zgs 682 ic zgs 682 i gas hob instruction booklet ie gb.
Page 2
2 thank you for selecting our appliance thank you for selecting our appliance thank you for selecting our appliance thank you for selecting our appliance thank you for selecting our appliance we wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again whe...
Page 3: Contents
3 contents important safety information important safety information important safety information important safety information important safety information ......................................................... ......................................................... ...............................
Page 4: Important Safety Information
4 important safety information y y y y you must r ou must r ou must r ou must r ou must read these war ead these war ead these war ead these war ead these war nings car nings car nings car nings car nings carefully befor efully befor efully befor efully befor efully before installing or e installing...
Page 5
5 z ensure the control knobs are in the ‘off’ position when not in use. Z when using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance. Z unstable or misshapen pans should not be used on the hob as unstable pans can cause an accid...
Page 6: Description of The Hobs
6 1. Hob top 2. Auxiliary burner 3. Semi-rapid burner 4. Triple crown burner 5. Control knobs description of the hobs 5 1 3 3 4 2.
Page 7: Regulations.
7 installation any gas installation must be carried out by a registered competent person, and in accordance with existing rules and regulations. The relevant instructions are to be found in the second section of this manual. Please, ensure that, once the hob is installed, it is easily accessible for...
Page 8: Only For Model Zgs 682 Ict
8 lighting the burners lighting the burners lighting the burners lighting the burners lighting the burners for easier lighting, proceed before putting for easier lighting, proceed before putting for easier lighting, proceed before putting for easier lighting, proceed before putting for easier lighti...
Page 9: Seconds.
9 do not keep the control knob pressed for more than 15 seconds. If the burner does not light even after 15 seconds, release the control knob, turn it the "off" position and wait for at least one minute before trying to light the burner again. When switching on the mains, after installation or a pow...
Page 10
10 as soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering. Use only pans or pots with flat use only pans or pots with flat use only pans or pots with flat use only pans or pots with flat use only pans or pots with flat bottom. Bottom. Bottom. Bottom....
Page 11: Maintenance and Cleaning
11 before any maintenance or cleaning can be carried out, you before any maintenance or cleaning can be carried out, you before any maintenance or cleaning can be carried out, you before any maintenance or cleaning can be carried out, you before any maintenance or cleaning can be carried out, you mu...
Page 12
12 pay attention when replacing the pan pay attention when replacing the pan pay attention when replacing the pan pay attention when replacing the pan pay attention when replacing the pan supports in order to avoid damaging supports in order to avoid damaging supports in order to avoid damaging supp...
Page 13: Something Not Working?
13 something not working? If the hob is not working correctly, please carry out the following checks before contacting your local service force centre. Symptom symptom symptom symptom symptom there is no spark when lighting the gas. The gas ring burns unevenly. Solution solution solution solution so...
Page 14
14 overall dimensions overall dimensions overall dimensions overall dimensions overall dimensions width: 594 mm depth: 510 mm cut out dimensions cut out dimensions cut out dimensions cut out dimensions cut out dimensions width: 560 mm depth: 480 mm thickness: 30 mm suppl suppl suppl suppl supply con...
Page 15
15 burner semi-rapid a u x i l i a r y triplecrown position m a x min m a x min m a x min nominal thermal power kw 2.0 0.45 1.0 0.33 4.0 1.2 nominal flow rate m 3 /h 0.190 0.038 0.095 0.028 0.381 0.114 nozzle reference 9 6 adjust. 7 0 adjust. 14 6 adjust. 1/100 mm nominal thermal power kw 2.0 0.45 1...
Page 16
16 important safety requirements this hob must be installed in accordance with the gas safety (installation and use) regulations (current edition) and the iee wiring regulations (current edition). For appliances installed in the republic of ireland please refer to nsai- domestic gas installation i.S...
Page 17: Installation
17 a) end of shaft with nut b) washer c) elbow installation impor impor impor impor impor t t t t tant ant ant ant ant this hob must be installed by a competent person to the this hob must be installed by a competent person to the this hob must be installed by a competent person to the this hob must...
Page 18
18 it is important to install the elbow corr it is important to install the elbow corr it is important to install the elbow corr it is important to install the elbow corr it is important to install the elbow correctly ectly ectly ectly ectly, with the shoulder on , with the shoulder on , with the sh...
Page 19
19 600 min. Location location location location location the hob may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom, shower room or garage. Ensure that there is a minimum distance of 55 mm between the rear cut out edge and the wall. A minimum distance of 100 mm m...
Page 20: Fitting The Hob Into The
20 fitting the hob into the worktop carry out the building in of the hob as follows: 1. Place the seals supplied with the hob on the front edge of the cut out. Then, place them at 11 mm from the side edges and at 10 mm from the rear edge, as shown in the diagram, taking care that the seals meet with...
Page 21: Building In
21 2 b b b b building over a kitchen unit uilding over a kitchen unit uilding over a kitchen unit uilding over a kitchen unit uilding over a kitchen unit with door with door with door with door with door proper arrangements must be taken in designing the furniture unit, in order to avoid any contact...
Page 22: Electrical Connections
22 electrical connections any electrical work required to install this hob should be any electrical work required to install this hob should be any electrical work required to install this hob should be any electrical work required to install this hob should be any electrical work required to instal...
Page 23: Wiring Diagram
23 wiring diagram permanent connection permanent connection permanent connection permanent connection permanent connection in the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm betwe...
Page 24: Fault Finding
24 fault finding preliminary electrical systems check preliminary electrical systems check preliminary electrical systems check preliminary electrical systems check preliminary electrical systems check s t a r t s t a r t s t a r t s t a r t s t a r t isolate appliance and carry out: a: a: a: a: a: ...
Page 25
25 a. Earth continuity check a. Earth continuity check a. Earth continuity check a. Earth continuity check a. Earth continuity check appliance must be electrically disconnected - meter set on w (ohms) x 1 scale and adjust zero if necessary. — test leads from any appliance earth point to earth pin on...
Page 26
26 check gas supply at burner ignition system / gas ignition ignition system / gas ignition ignition system / gas ignition ignition system / gas ignition ignition system / gas ignition yes yes yes yes yes check plug top fuse and replace if necessary check polarity and earth continuity of supply poin...
Page 27: Commissioning
27 commissioning when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. 1) turn the gas tap to the max position and ignite. 2) set the gas tap to the min flame position then turn the control knob from min to max several ...
Page 28
28 conversion from natural gas to lpg impor impor impor impor import t t t tant ant ant ant ant the replacement/conversion from natural gas to lpg should only the replacement/conversion from natural gas to lpg should only the replacement/conversion from natural gas to lpg should only the replacement...
Page 29: Guarantee/customer Service
29 guarantee/customer service standard guarantee conditions standard guarantee conditions standard guarantee conditions standard guarantee conditions standard guarantee conditions we, zanussi-electrolux, undertake that if within 12 months of the date of the purchase this zanussi-electrolux appliance...
Page 30
30 service and spare parts service and spare parts service and spare parts service and spare parts service and spare parts in the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local service force centre by telephoning 0870 5 929 929 0870 5 929...
Page 31: European Guarantee
31 this appliance is guaranteed by electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move w...
Page 32
32.
Page 33
33.
Page 34
34.
Page 35
35.
Page 36
35699-4701 01/08 r.0 www.Zanussi-electrolux.Co.Uk.