- DL manuals
- Zanussi
- Oven
- ZHM 773
- Instruction Booklet
Zanussi ZHM 773 Instruction Booklet
Summary of ZHM 773
Page 1
60 notice d'utilisation gebrauchsanweisung gebruiksaanwijzing instruction booklet fours multifonctions einbau-herde meer-systemen inbouw-fornuizen built-under oven zhm 773.
Page 2: For Your Safety
61 for your safety • this appliance has been designed to be operated by adults and children under supervision. Young children must not be allowed to tamper with the controls or play near or with the oven. • this appliance has been designed for cooking edible foodstuff only and must not be used for a...
Page 3: 1. The Control Panel
62 1. The control panel control knob for front left hotplate control knob for rear left hotplate control knob for rear right hotplate control knob for front right hotplate oven controls and electronic programmer control knob for front left hotplate control knob for rear left hotplate control knob fo...
Page 4
63 fo 2165 0 1 2 3 1 2 3 4 5 6 7 8 9 1. On / off 2. Oven function control 3. Fast heat up function / defrosting 4. Current/setting temperature / time of day 5. Decreasing control (time or temperature) 6. Increasing control (time or temperature) 7. Minute minder 8. Cooking time 9. End of cooking time...
Page 5
64 how to select a cooking function — set the oven on by pressing button 1 — press button 2 to select the required oven function. Each time button 2 is depressed, a pilot light will come on to the left of the currently selected function symbol. Here below is a list of the function symbols and their ...
Page 6
65 "fast heat up" function after a cooking function has been selected and the temperature has been adjusted, the cavity will gradually heat up until the selected temperature is reached. This will take from 10 to 15 minutes, depending on selected function and temperature. If it is necessary to reach ...
Page 7
66 to open the oven door, always catch the handle in its central part (fig. 2). 3. When the oven is first installed fig. 2 fo 0799 once the oven has been installed : — the numbers on the display will flash and indicate "12.00". If no button is pressed in 10 seconds, the numbers will stop flashing an...
Page 8: 4. Programming
67 4. Programming how to set the minute minder — press button 7 to select the minute minder function. The minute minder pilot light will flash and the control panel will display 0.00. — press button 5 or 6 to select the required time. Maximum time is 19 hours 59 minutes. — after the setting is carri...
Page 9
68 how to make the oven switch on and off automatically — carry out the cooking duration setting as described in the relevant chapter. — press button 9. The "end of cooking" function will be selected, and the relevant pilot lamp will flash. The control panel will display the end of cooking time (tha...
Page 10: 5. Using The Oven
69 5. Using the oven • always use oven gloves to remove and replace food in the oven. • the temperatures inside the oven can reach 250 ° c. Always ensure that you are using oven proof baking trays, oven dishes, etc. • do not place pans, biscuit pans or aluminium foil directly on the base of the oven...
Page 11: 6. Cooking Tables
70 temp. Meat 1000 beef 2 200 2 175 50 ~ 70 on grid 1200 pork 2 200 2 175 100 ~ 130 on grid 1000 veal 2 200 2 175 90 ~ 120 on grid 1500 english roast beef 2 220 2 200 50 ~ 70 on grid 1200 lamb 2 200 2 175 110 ~ 130 leg 1000 chicken 2 200 2 175 60 ~ 80 whole 4000 turkey 2 200 2 175 210 ~ 240 whole 15...
Page 12
71 cakes whipped up kneading 2 (1 and 3)* 160 45 ~ 60 leavened kneading 2 (1 and 3)* 160 20 ~ 35 shortbread dough 2 (1 and 3)* 160 20 ~ 30 butter-milk cheese cake 2 150 60 ~ 80 apple cake 2 (1 and 3)* 160 40 ~ 60 strudel 2 (1 and 3)* 150 60 ~ 80 jam-tart 2 (1 and 3)* 160 45 ~ 60 small cakes 2 (1 and...
Page 13: 7. Cleaning and Maintenance
72 7. Cleaning and maintenance general cleaning • before cleaning, always allow the oven to cool down. • when using spray cleaning products, be careful not to spread them on the heating elements or on the thermostat sensor. • never use harsh abrasives, steel wool or cleaners with bleach, as they cou...
Page 14
73 the oven door gasket the correct operation of the oven is ensured by a gasket placed round the edge of the oven cavity. • periodically check the condition of this gasket. If necessary, clean it without using abrasive cleaning products. • if the gasket shows to be damaged, call you local zanussi s...
Page 15
74 replacing the oven light • ensure the electricity supply is switched off before carrying out this operation. The oven bulb has to comply to these features: a) resistant to temperatures of 300 ° c; b) electric rate: 230 v - 50 hz; c) electric power rate: 25 w.; d) connection type: e 14. To replace...
Page 16: 10. Guarantee
75 if after the checks listed in the previous chapter, the appliance still does not work correctly, contact your locals zanussi service centre, specifying the type of malfunctioning, the appliance model (mod.), the product number (prod. No.) and the serial number (ser. No.) marked on the identificat...
Page 17: 11. Technical Data
76 this appliance complies with the following e.E.C. Directives: - 73/23 - 90/683 (low voltage directive); - 89/336 (electromagnetical compatibility directive); - 93/68 (general directives) and subsequent modifications. Height 59,4 cm width 56,0 cm depth 55,0 cm height 32,5 cm width 42,0 cm depth 39...
Page 18
77 fo 0414 the following instructions are meant to a qualified technician, in order to allow him carry out the installation in compliance with the rules in force. The building-in and the electrical connection fo the appliance must be carried out by a qualified and authorized technician only. Buildin...
Page 19
78 fo 0332 fo 0331 fig. 14 fig. 13 fo 0039 fig. 15 undertop building in figures 13 and 14 show two possible solutions. In fig. 13 the appliance leans on two wood supports which are fixed to the side of the furniture unit. In fig. 14 the appliance leans on two “c” shaped or “l” shaped metal supports,...
Page 20: 13. Electrical Connection
79 the manufacturer disclaims any responsability should all the safety measures not be carried out. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load; 2) check that the power supply is properly earthed in compliance with the current rul...