- DL manuals
- Zanussi
- Oven
- ZHQ 631
- Instruction Booklet
Zanussi ZHQ 631 Instruction Booklet
Summary of ZHQ 631
Page 1
Electric ovens elektro-einbauherde fours Électriques meer-systemen inbouw- fornuizen hornos elÉctricos fornos elÉctrico zhq 631 - zhq 861 instruction booklet - gebrauchsanweisung notice dutilisation - gebruiksaanwijzing manual de instrucciones - instruÇÕes de utilizaÇÃo.
Page 2
2 this appliance complies with the following e.E.C. Directives: - 73/23 - 90/683 (low voltage directive); - 89/336 (electromagnetical compatibility directive); - 93/68 (general directives) and subsequent modifications. English these warnings are provided in the interest of safety. You must read them...
Page 3
3 oven door protection device (stainless steel models) all our appliances comply with the european safety standards. Nevertheless, in order to ensure the highest safety level, and avoid little children to be exposed to the heat when the appliance is operated, it is possible to fit a special protecti...
Page 4: 100
4 5 10 15 30 45 60 75 90 fo 2588 fig. 5 end of cooking programmer (zhq 631) this device (fig. 5) allows you to make the oven switch off automatically once the preset time is over. An acousitic signal will be heard when the cooking is completed.The cooking duration can be set up to 90 minutes maximum...
Page 5
5 the safety thermostat this oven is provided with a safety thermostat. In case of malfunctioning of the main thermostat, and consequent over-heating, the safety device will stop the power supply to the appliance. If this happens, call your local service centre. Under no circumstances should you att...
Page 6
6 electronic programmer (zhq 861) 1. Push button for selecting a function 2. Decreasing control button 3. Increasing control button 4. Display 5. cooking duration pilot lamp 6. end of cooking pilot lamp 7. minute minder pilot lamp 8. time of day pilot lamp the oven will work only if ...
Page 7
7 end of cooking function thanks to this function, you can set the oven to switch off automatically when a programmed end of cooking time is over. Place food in the oven, select a cooking function and adjust the cooking temperature. Press button repeatedly to select the end of cooking function. ...
Page 8
8 using the oven conventional cooking turn the oven function control knob to the relevant symbol ( ) and set the thermostat knob on the required temperature. If you need more heat from the top or the bottom of the oven, turn the oven function control knob to (top heating element only) or (bottom hea...
Page 9
9 temp. Cakes whipped up kneading 2 180 2 (1 and 3)* 160 45 ~ 60 leavened kneading 2 180 2 (1 and 3)* 160 20 ~ 35 shortbread dough 2 180 2 (1 and 3)* 160 20 ~ 30 butter-milk cheese cake 1 175 2 150 60 ~ 80 apple cake 1 180 2 (1 and 3)* 160 40 ~ 60 strudel 2 175 2 (1 and 3)* 150 60 ~ 80 jam-tart 2 18...
Page 10
10 cleaning and maintenance general cleaning before carrying out any cleaning or manteinance work, always disconnect the appliance from the electrical supply, and allow it to cool down. when using spray cleaning products, be careful not to spread them on the heating elements or on the thermostat s...
Page 11
11 fig. 9 fo 0288 the oven door and its gasket before cleaning the oven door, we recommend you to remove it from the oven.Proceed as follows: a) open the oven door completely; b) find the hinges linking the door to the oven (fig. 9); c) unlock and turn the small levers located on the two hinges (fig...
Page 12
12 solution ucheck that both a cooking function and a temperature have been selected or ucheck the appliance is wired in properly, and the socket switch or the switch from the mains supply to the oven are on. Uturn the thermostat knob on a temperature or uturn the oven function control knob on a fun...
Page 13
13 recess dimensions height 59,4 cm width 56,0 cm depth 55,0 cm oven cavity dimensions height 32,5 cm width 42,0 cm depth 39,0 cm volume 53 l technical data the following instructions are meant to a qualified technician, in order to allow him carry out the installation in compliance with the rules i...
Page 14
14 before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load; 2) check that the power supply is properly earthed in compliance with the current rules; 3) check the socket or the double pole switch used for the electrical connection can be easil...
Page 15
15 when calling for repairs during the period of guarantee ofthe appliance, the original invoice or receipt must be shown or sent together with the appliance to be repaired. General conditions of guarantee 1 the manufacturer guarantees the appliance indicated on the relative invoice for a period of ...