Summary of ZI 9121 FA
Page 1
Freezer zi 9121 fa instruction booklet 2222 753-65.
Page 2
2 printed on paper manufactured with environmentally sound processes general safety • this appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorised technicians. • take utmost care when handling your appliance so as not to cause ...
Page 3: Contents
Servicing • this product should be serviced by an authorised engineer and only genuine spare parts should be used. • under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local...
Page 4: Operation
4 freezer controls starting your appliance insert the plug into the wall socket. The appliance can be activated by turning the thermostat knob (2) beyond the «o» position. When the pilot light (1) is illuminated and a sound is on only for 2 sec. This shows that the appliance is on. Push the button (...
Page 5
5 temperature acoustic alarm this appliance incorporates an alarm which gives off an audible signal whenever the warning light comes on. This signal can be temporarily stopped by depressing the push button for fast-freezing (4). The fast-freezing push button can be released as soon as the warning li...
Page 6
6 normal operating sounds you may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the fixed freezer shelves. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from ...
Page 7: Health and Safety Guidelines
7 important in the event of a power failure causing the temperature within your freezer to rise, do not re- freeze the food without checking its condition. The following guidelines should assist you: ice-cream: once thawed should be discarded. Fruits & vegetables: if soft should be cooked and used u...
Page 8: Defrosting
8 the freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 1/4". During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, w...
Page 9: Maintenance and Cleaning
9 maintenance and cleaning warning before any maintenance or cleaning work is carried out, disconnect the appliance from the electricity supply. Important this appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians....
Page 10: Something Not Working?
10 something not working? Before contacting your local service force centre check the following points. Important: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Sympto...
Page 11: Service and Spare Parts
11 service and spare parts in the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local service force centre by telephoning:- 08705 929929 your telephone call will be automatically routed to the service force centre covering your post code area....
Page 12: Guarantee Conditions
12 standard guarantee conditions we, zanussi, undertake that if within 24 months of the date of purchase this zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same free of charge for labour...
Page 13: Technical Specifications
13 power supply voltage and frequency 220-240 v / 50 hz total power absorbed 100 w average daily units electricity(*) 0,57 kwh gross capacity 110 l net capacity 94 l star rating (*)this figure is based on standard test results in accordance with european standard en153 (actual consumption will depen...
Page 14: Door Reversal
14 door reversal the appliance’s door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. Attention after completion of the door reversing operation, check that the door gasket adheres t...
Page 15: Electrical Connection
15 if you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: connect the green and the yellow (earth) wire to the terminal in the plug which is marked with the letter «e» or...
Page 16: Building In
16 dimensions of the recess height of housing (1) mm 880 depth of housing (2) mm 550 width of housing (3) mm 560 it is necessary that the cabinet has a ventilation recess with the following dimensions: depth 50 mm width 540 mm building in pr0 540 50 3 2 1 for appropriate venting, follow indications ...
Page 17
17 pr167 ha hb 8mm 6. Place guide (ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 8. Open the appliance door and the furniture door at 90°. Insert the small ...
Page 18
18 10. Place the small square on the guide again and fix it with the screws supplied. Should the alignment of the furniture door be necessary, use the clearance of slots. At the end of this procedure, it is necessary to check if the door of the furniture closes properly. Pr168 hb 11. Fix cover (hd) ...
Page 20
© electrolux plc 2005.