Summary of ZKH 2145
Page 1
En user manual washer dryer zkh 2145.
Page 2
Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 automatic drying programmes _ _ _ _ _ _ _ _ _ _ _ 10 timed drying pro...
Page 3
• after having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall. • if the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the...
Page 4
Product description 1 detergent dispenser drawer 2 control panel 3 door opening handle 4 rating plate 5 drain pump 6 adjustable feet 1 2 3 4 5 6 detergent dispenser drawer compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available)...
Page 5
Control panel on the following page there is a picture of the control panel. It shows the programme selector dial as well as the buttons, pilot lights and the display. These are presented by relevant numbers on the following pages. 1 2 3 4 5 6 7 8 10 9 1 programme selector dial 2 spin button 3 autod...
Page 6
= iron dry = delay start 1-8 programme selector dial, spin speed button, drying level and time, and available options programme selector dial it allows you to switch the appliance on/off and/or to se- lect a programme. Spin by pressing this button you can change the spin speed of the selected progra...
Page 7
• delayed start the selected delay set by pressing the relevant button appears on the display for a few seconds, then the du- ration of the selected programme is displayed again. The delay time value decreases by one unit every hour and then, when 1 hour remains, every minute. • alarm codes in the e...
Page 8
Programme - maximum and minimum temperature - cycle de- scription - maximum spin speed - maximum fabrics load - type of laundry options detergent compart- ment synthetics 60° - 30° main wash - rinses maximum spin speed at 900 rpm max. Load 3 kg - reduced load 1,5 kg 1) synthetic or mixed fabrics: un...
Page 9
Programme - maximum and minimum temperature - cycle de- scription - maximum spin speed - maximum fabrics load - type of laundry options detergent compart- ment sport intensive 40° prewash - main wash - rinses maximum spin speed at 900 rpm max. Load 2,5 kg this programme is suitable for washing heavi...
Page 10
Automatic drying programmes degree of drying type of fabric max load store dry suitable for items to put away without ironing cotton and linen (bathrobes, bath towels, etc) 3,5 kg store dry suitable for items to put away without ironing synthetics and mixed fabrics (jumpers, blouses, underwear, hous...
Page 11
Dried grease stains: moisten with turpentine, lay the gar- ment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure wi...
Page 12
Ers, quilts, sleeping bags and duvets must not be ma- chine dried. • avoid drying dark clothes with light coloured fluffy items such as towels as these can attract the fluff. • remove the laundry when the appliance has finished drying. • to avoid a static charge when drying is completed, use either ...
Page 13
There are two different ways to set this option: 1. Before pressing button 7: it will be impossible to start the machine. 2. After pressing button 7: it will be impossible to change any other programme or option. To enable or disable this option press simultaneously for about 6 seconds buttons 2 and...
Page 14
Select the delay start by pressing button 8 before you start the programme, if you wish to delay the start, press this button to select the desired delay. The selected delay time value will appear on the display for a few seconds, then the duration of the programme will appear again. You must select...
Page 15
Brightness of the display is reduced. By pressing any but- ton the appliance will come out of the energy saving sta- tus. Use - drying drying only caution! The recommended load size is 3,5 kg for cottons and lin- en and 2 kg for synthetic items. By pressing drying time button it is also possible to ...
Page 16
For cottons and synthetic the lowest value you can select is 900 r.P.M. 5. Set the dryness degree by pressing button 3. The display shows the whole duration of the washing and the set drying cycle. 6. Start the programme by pressing button 7. The time remaining is updated every minute on the display...
Page 17
Cleaning the drawer recess having removed the draw- er, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme with- out any clothes in the drum. Drain pump the pump should...
Page 18
Replace the filter into the pump by inserting it correctly into the special guides. Screw the pump cover firmly by turning it clockwise. Replace the emergency emptying cap into the pump cover and fix it firm- ly. Close the pump door. Warning! When the appliance is in use and depending on the program...
Page 19
• open the pump door; • place a bowl on the floor. Remove the emergency emp- tying cap from the filter. The water should drain by gravity into the bowl. When the bowl is full, refit the emergency emptying cap into the filter. Empty the bowl. Repeat the procedure until water stops flowing out; • clea...
Page 20
Problem possible cause/solution the machine does not fill: the water tap is closed. • open the water tap. The inlet hose is squashed or kinked. • check the inlet hose connection. The filter in the inlet hose or the inlet valve filter are blocked. • clean the water inlet filters. (see "cleaning the w...
Page 21
Problem possible cause/solution the door will not open: the programme is still running. • wait the end of washing cycle. The door lock has not been released. • wait until the pilot light 9 goes off. There is water in the drum. • select drain or spin programme to empty out the water. The machine vibr...
Page 22
If you are unable to identify or solve the problem, contact our service centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: the service centre will require this information. Mod. ... ... ... Pr od. No. ... ... ... Ser . No. ... ... ... Mo d . .. . ....
Page 23
Installation unpacking all transit bolts and packing must be removed before us- ing the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. After removing all the packaging, carefully lay machine on it's back to re- mov...
Page 24
35° 45° open the porthole and extract the inlet hose. Connect the hose with the angled connection to the ma- chine. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. Connect the ho...
Page 25
Electrical connection information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use. Caution! Connect the machine...
Page 26
26.
Page 27
27.
Page 28
Www.Zanussi.Com/shop 1329 36570-a-122011.