Operating and installation instruction electric ceramic-glass hob zkl 64 w - zkl 64 b zkl 64 n - zkl 64 x gb 319 3900-00 k/rd-sd 980223.
14 important hints on safety prior to the first use of the appliance do make your- self familiar with the instruction manual. Pay spe- cial attention to the hints on safety. In this manual they are marked with a . This will prevent from damages to persons as well as to the appliance itself. Do caref...
15 overall view zkl 64 w zkl 64 b zkl 64 n zkl 64 x 1. Cooking zone Ø 180 mm, 1700 w 2. Cooking zone Ø 145 mm, 1200 w 3. Cooking zone Ø 180 mm, 1700 w 4. Cooking zone Ø 145 mm, 1200 w 5. Residual heat indicator 6. Hotplate switches voltage ac 230 v total connected load 5,8 kw 1 2 3 4 5 6 prior to th...
16 hob instructions ceramic glass surface the cooking surface is made of proven ceramic glass. The surface is non--porous and, in addition, insensitive to quick variations in temperature. Therefore pots may be moved from a hot to a cold zone. When switching on the cooking zones there may occur a sho...
17 residual heat indicator the residual heat indicator with 1 indicator lamp is loca- ted between the two front cooking zones. The lamp comes on in case the temperature of switched on coo- king zones will reach more than (abt.) 60 o c. Also after switch--off the lamp will remain on until cooling dow...
18 cleaning and care clean your glass--ceramic hob thoroughly and regular- ly, when it is hand--hot or cold. Avoid frequent burning in of soiling. Suitable for cleaning are: clean cloths or paper towels, cleansing agents such as cerafix, stahl-fix, wk top a.S.O. And a razor blade scra- per supplied ...
19 installation instructions the appliance must exclusively be con- nected to the mains by an expert electri- cian. With the installation and in case of a service fai- lure the appliance has to be isolated from the mains. Fuselage to be switched off or removed. The general rules for the operation of...
20 when building in ceramic glass cooking areas the front cross-rail of the build-in cupboard must be removed in order to have the heat radiating off escape without any obstacles. The space under the hob unit must be closed at all sides in a way that the lower side of the cooking area is no longer a...
21 electric connection the mains connection must be carried out by an expert electrician. The vde-regulations and the valid pre- scriptions by the local power suppy boards have to be compiled with. Prior to connection it should be checked whether the voltage stated on the type plate -- i.E. The nomi...
22 what to do in case of an error ? Put all selectors on the off-position. Fuselage to be switched off or unscrewed. Call an electrician or the after-sales service. Urgent ! Note down here the data from the type plate of your appliance. Same is to be seen on the bottom of your hob. Make always refer...
319 3900-00 - k/rd-sd 980928.