Zanussi ZOS 745 Instruction Booklet - Setting The Time of Day

69

Setting the time of day

When the power supply is switched on, or after a power

failure, the “Time of day” pilot lamp    will flash on the

display.

To set the correct time of day:

1. press button “ ” or “ ”.

2. After the setting is carried out, wait for 5 seconds: the

“Time of day” pilot lamp    will go out and the display

will show the set time. The appliance is ready for use.

To reset the correct time of day:

1. press button  repeatedly to select the  “Time of day”

function. The relevant pilot lamp will start flashing. Then

proceed as described above.

The time of day may be reset only if no automatic

function (cook duration 

 or end of cooking 

)

has been set.

“Cooking Duration” function 

Thanks to this function, the oven will automatically switch

off at the end of a programmed cooking duration time.

Place  food in the oven, select a cooking function and

adjust the cooking temperature. Press button  repeatedly

to select the “Cooking  Duration” function. The relevant pilot

lamp    will start flashing. Then, proceed as follows:

To set the duration time:

1. press button “ ” or “ ”.

2. After the setting is carried out, wait for 5 seconds: the

"Cooking Duration" pilot lamp   will come on and the

display will revert to the time of day.

3. When cooking time is over, the oven will be switched

off automatically and an acoustic alarm will be heard,

while the pilot lamp will start flashing. Turn the oven

function and the thermostat control knob to zero.

To switch off the acoustic alarm, press any button.

NOTE: when doing this operation, the oven will be

operated again, therefore, remember to turn the oven

function and the thermostat control knob to zero at

the end of the cooking time.

To cancel the duration time:

1. Press button  repeatedly to select the “Cooking

Duration” function. The relevant pilot lamp   will flash

and the display will show the remaining cooking time.

2. Press button “ ” until the display shows “0:00”. After

5 seconds the pilot lamp will go out and the display

will revert to the time of day.