Zanussi ZWG 6100 K User Manual - Troubleshooting

1.

1

2

3

2.

3.

4.

45°

20°

Frost precautions

If the appliance is installed in an area where the

temperature can be less than 0 °C, remove the

remaining water from the inlet hose and the

drain pump.

1.

Disconnect the mains plug from the

mains socket.

2.

Close the water tap.

3.

Remove the water inlet hose

4.

Remove the drain hose from the rear

support and unhook it from sink or spigot

5.

Put the ends of the drain and inlet hose

in a container. Let the water flow out of

the hoses.

6.

When no more water flows, install the in-

let hose and the drain hose again.

Warning! Make sure that the temperature

is more than 0 °C before you use the

appliance again.

The manufacturer is not responsible for

damages caused by low temperatures.

Troubleshooting

The start of the appliance does not occur or the

appliance stops during operation.

First try to find a solution to the problem (refer

to the table). If not, contact the Service.

During appliance operation it is possible that

the red indicator of button Start / Pause flash-

es and one of the indicators comes on, to show

that the appliance does not operate:

• Washing : the appliance does not fill with

water.

• Extra Rinse : the appliance does not drain

the water.

• End : the appliance door is open or not

closed correctly.

Problem

Possible solution

The appliance does not

start.

Make sure that the mains plug is connected in the mains socket.

14

www.zanussi.com