Summary of ZWG 7120 P
Page 1
En user manual washing machine zwg 7120 p zwg 7140 p.
Page 2
Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 installation _ _ _ _ _ _ _ ...
Page 3
Is not pressing the electrical supply cable against the wall. • install the appliance on a flat hard floor. • never place cardboard, wood or similar materials un- der the appliance to compensate for any unevenness in the floor. • if the appliance is situated on a carpeted floor, please adjust the fe...
Page 4
To activate this device, ro- tate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin. To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise un- til the groove is vertical. Frost precaut...
Page 5
Ecological hints to save water, energy and to help protect the environment, we recommend that you follow these tips: • normally soiled laundry may be washed without pre- washing in order to save detergent, water and time (the environment is protected too!). • the machine works more economically if i...
Page 6
Water supply pressure minimum maximum 0,05 mpa 0,8 mpa maximum load cotton 6 kg spin speed maximum 1200 rpm (zwg7120p) 1400 rpm (zwg7140p) installation unpacking warning! • read carefully the "safety information" chapter before installing the appliance. X 3 x 3 x 2 x 1 b a c warning! Remove and keep...
Page 7
• remove the power supply cable and the draining and inlet hose from the hose holders ( c ) on the rear of the appliance. • unscrew the three bolts ( a ) and remove the hose holders ( c ). • slide out the relevant plastic spacers ( b ). • plug the smaller upper hole and the two large ones with the c...
Page 8
Accurate levelling prevents vibration, noise and dis- placement of the appliance during operation. Repeat the levelling action, if the appliance is not level and stable. Water inlet connect the hose to a tap with a 3/4” thread. 35° 45° loosen the ring nut to angle the hose to the left or right depen...
Page 9
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local centre. Connections overview 115 cm 140 cm m c 150 m c 100 max 100 cm min. 60 cm max 100 cm min. 60 cm m c 9 0 m c 115 electrical connection • the appliance must be earthe...
Page 10
First use • ensure that the electrical and water connections comply with the installation instructions. • ensure that the drum is empty. • before the first wash, run a cotton cycle at the highest temperature without any laundry in the machine, to remove any manufacturing residue from the drum and tu...
Page 11
Not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains : treat with bleach, rinse well (whites and fast coloureds only). Grass : soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue : moisten with ace...
Page 12
If the water hardness degree is medium or high we suggest you to add a water softener following always the manu- facturer’s instructions. When the degree of hardness is soft, readjust the quantity of the detergent. Open the detergent dispenser drawer compartment for powder or liquid detergent used f...
Page 13
Warning! Do not use the flap in "down" position with: • gelatinous detergent or thick detergent. • powder detergent. • with programmes with prewash. • do not use liquid detergent if the washing programme doesn't start immediately. In all above listed cases, use the flap in "up" posi- tion . Measure ...
Page 14
1 programme selector dial turn the programme selector dial to the required programme. The selector dial can be turned either clockwise or counter-clockwise. The green pilot light of the button 9 starts flashing: the appliance is now switched on. If you turn the programme selector dial to another pro...
Page 15
5 super quick by pressing this button the corresponding pilot light illuminates. Short cycle for lightly soiled items or for laundry which needs only fresh- ening up. With this option, a reduced load of laundry is recommended: • cottons 3 kg • synthetics and delicates 1,5 kg extra rinse this applian...
Page 16
7 display 7.1 7.2 7.3 the display shows the following information: 7.1 delay start icon 7.2 child safety lock this device permits you to leave the appliance unattended during it's func- tioning. 7.3 • duration of the selected programme after selecting a programme, the duration is displayed in hours ...
Page 17
8 the programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button. Before you start the programme, if you wish to delay the start, press this button to select the desired delay. The selected delay time value will appear on th...
Page 18
9 start the programme by pressing the button 9 • to start the selected programme, press the button 9 , the corresponding green pilot light stops flashing. The pilot light 10 illuminates to indicate that the appliance starts operating and the door is locked. If you have chosen a delayed start, the ap...
Page 19
Display go off. The green pilot light of the button 9 flashes with a low frequency. By pressing any button the appli- ance will come out of the energy saving status. Door seal at the end of every cycle, check from the door seal and remove objects that could be trapped in the fold. Washing programmes...
Page 20
Programme - maximum and minimum temperature - cycle de- scription - maximum spin speed - maximum fabrics load - type of laundry options detergent com- partment mixed fabric 20° main wash - rinses - maximum spin speed: 900 rpm for zwg7120p - 1200 rpm for zwg1740p max. Load 3 kg highly energy efficien...
Page 21
Programme - maximum and minimum temperature - cycle de- scription - maximum spin speed - maximum fabrics load - type of laundry options detergent com- partment spin drain and long spin at maximum spin speed: 1200 rpm for zwg7120p - 1400 rpm for zwg1740p max. Load 6 kg separate spin for hand washed g...
Page 22
Programme energy consumption (kwh) water consumption (litres) programme duration (hours.Minutes) cottons 60° 1.30 69 the display on the control panel. Cotton eco 60° 1) 1.02 49 cottons 40° 0.75 69 synthetics 40° 0.60 57 delicates 40° 0.60 65 wool/ handwash 30° 0.40 50 1) « cotton eco » at 60°c with ...
Page 23
• use the previous brush to clean the recess, en- suring that upper and lower part of it is well cleaned. After having cleaned the dispenser and the drawer re- cess, replace it. Cleaning the drain filter the filter permits to hold fluff or foreign bodies left un- awares in the laundry. The pump must...
Page 24
Cleaning the water inlet filters important! If the appliance doesn't fill, it takes a long time to fill with water, the starting button flashes red or the display (if available) shows the relevant alarm (see chapter "what to do if..." for more details), check if the water inlet filters are blocked ....
Page 25
Fault code and malfunction possible cause / solution problem with the water drain- age the drain hose is squashed or kinked. • check the drain hose connection. The drain filter is clogged. If the appliance stops working without discharging the water , first carry out an emergency drain: • turn the p...
Page 26
Malfunction possible cause / solution the appliance does not start: the plug is not properly inserted in the power socket. • insert the plug into the power socket. There is no power at the socket. • please check your domestic electrical installation. The main fuse has blown. • replace the fuse. The ...
Page 27
Malfunction possible cause / solution the appliance vibrates noisi- ly: the transit bolts and packing have not been removed. • check the correct installation of the appliance. The appliance is not levelled correctly. • adjust the feet. The laundry is not evenly distributed in the drum. • redistribut...
Page 28
The necessary data for the service centre is on the rating plate. We recommend that you write the data here: mod. ... ... ... Pr od. No. ... ... ... Ser . No. ... ... ... Mo d . .. . ... .. . Pr od. N o . .. . ... . . S er . No . ... .. . ... Model description (mod.) ............................... ...
Page 29
29.
Page 30
30
Page 31
31.
Page 32
Www.Zanussi.Com/shop 132 948 930 - 00 - 16 201 0