Summary of ZWH 6125
Page 1
Gb user manual 2 washing machine zwh 6125.
Page 2
Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 first use _ _ _ _ _ _ _ ...
Page 3
• always be sure, that there is no water leakage from hoses and their connections after the installation. • if the appliance is installed in a location subject to frost, please read the “dangers of freezing” chapter. • any plumbing work required to install this appliance should be carried out by a q...
Page 4
Product description 1 detergent dispenser drawer 2 control panel 3 door opening handle 4 rating plate 5 drain pump 6 adjustable feet 1 2 3 4 5 6 detergent dispenser drawer compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available)...
Page 5
1 2 3 4 5 6 7 8 10 9 1 programme selector dial 2 spin button 3 options button 4 prewash button 5 easy iron button 6 extra rinse button 7 start/pause button 8 delay start button 9 door locked pilot light 10 display table of symbols = rinse hold = child safety lock 1-8 programme selector dial, spin sp...
Page 6
Rinses in some programmes. On other programmes (e.G. Cotton) the maximum spin speed is reduced automati- cally. Extra rinse this appliance is designed for saving energy. If it neces- sary to rinse the laundry using an extra quantity of water (extra rinse), select this option. Some additional rinses ...
Page 7
Washing programmes programme maximum and minimum temperature - cycle description - maximum spin speed - maximum fabrics load - type of laundry options detergent compart- ment cottons 90° - cold 1) main wash - rinses maximum spin speed at 1200 rpm max. Load 7 kg - reduced load 3.5 kg 2) white and col...
Page 8
Programme maximum and minimum temperature - cycle description - maximum spin speed - maximum fabrics load - type of laundry options detergent compart- ment jeans 40° main wash - rinses maximum spin speed at 1200 rpm max. Load 3.5 kg with this programme it is possible to wash items like pants, shirts...
Page 9
Programme maximum and minimum temperature - cycle description - maximum spin speed - maximum fabrics load - type of laundry options detergent compart- ment drain draining of water max. Load7 kg for emptying out the water of the last rinse in programmes with therinse hold option selected. Spin drain ...
Page 10
Not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with aceton...
Page 11
Personalisation acoustic signals the machine is provided with an acoustic device, which sounds in the following cases: • at the end of the cycle • if there is a fault. By pressing the 4 and 5 buttons simultaneously for about 6 seconds , the acoustic signal is deactivated (except if there is a fault)...
Page 12
When these buttons are pressed, the corresponding pilot lights illuminate. When they are pressed again, the pilot lights go out. If an incorrect option is selected, the inte- grated red pilot light of the button 7 flashes 3 times and the message err is displayed. For the compatibility among the wash...
Page 13
1. Turn the programme selector dial to . 2. Select the draining or spinning programme. 3. Reduce the spin speed if needed, by pressing the relevant button. 4. Press button 7 . At the end of the programme, the door is released and can be opened. Turn the programme selector dial to to switch the machi...
Page 14
Pull out the emergency emptying hose, place it in the container and remove its cap. When no more water comes out, unscrew the pump cover and remove it. Always keep a rag nearby to dry up spillage of water when removing the cover. Remove any objects from the pump impeller by ro- tating it. Put the ca...
Page 15
• when you intend to start the machine up again, make sure that the room temperature is above 0°c. Emergency emptying out if the water is not discharged, proceed as follows to empty out the machine: • pull out the plug from the power socket; • close the water tap; • if necessary, wait until the wate...
Page 16
Problem possible cause/solution the machine does not fill: the water tap is closed. • open the water tap. The inlet hose is squashed or kinked. • check the inlet hose connection. The filter in the inlet hose is blocked. • clean the water inlet hose filter. The door is not properly closed. • close th...
Page 17
Problem possible cause/solution the door will not open: the programme is still running. • wait the end of washing cycle. The door lock has not been released. • wait until the pilot light 9 goes off. There is water in the drum. • select drain or spin programme to empty out the water. The machine vibr...
Page 18
Technical data dimensions width height depth 60 cm 85 cm 63 cm electrical connection voltage - overall power - fuse information on the electrical connection is given on the rating plate, on the inner edge of the appliance door. Water supply pressure minimum maximum 0,05 mpa 0,8 mpa maximum load cott...
Page 19
After removing all the packaging, carefully lay machine on it's back to re- move the polystyrene base from the bottom. Remove the power supply cable and the hoses from the hose holders on the rear of the appliance. Unscrew the three bolts. Slide out the relevant plas- tic spacers. Open the porthole ...
Page 20
The other end of the inlet hose which connects to the appliance can be turned as showed in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After positioning the inle...
Page 21
21.
Page 22
22.
Page 23
23.
Page 24
Www.Zanussi.Com 132 95 263 0-00 -202 00 9.