Zap Zapino Owner's Manual - page 19
18
If the ZAPINO is not working, check the diagnostic light (break down
lights) above the speedometer, the signals are as follows:
First flash 3 and after a pause flash 3 times again:
Flash 1 time and after a pause then 1 time again:
First flash 1 time and after a pause then 2 times again:
First flash 1 and after a pause 4 times again:
First flash 1 and after a pause 5 times again:
First flash 3 times and after a pause 1 time again:
First flash 0 and after a pause 3 times again:
First flash 0 and after a pause 2 times again:
First flash 0 and after a pause 10 times again:
First flash 2 and after a pause 3 times again:
First flash 3 and after a pause 2 times again:
First flash 2 and after a pause 1 time again:
First flash 2 times:
£
£
£
£
£
£
£
£
£
£
£
£
£
problem with throttle spring, it didn't come back to normal position.
problem with brake, check brake level for kick stand released or not.
problem with connection of throttle, broken wire is loosened.
problem with voltage, battery too low (charge).
battery too high voltage.
problem with motor, overloaded.
problem with motor, overloaded.
the battery overload can't release enough current to motor.
motor thermal sensor problem.
overheat protection, leave to cool.
problem on controller current sensor. Restart the key or repair
controller.
Motor rotated hold back. Release the motor.
Brake light on, brake stuck on, or broken circuit.
Diagnostic Warning Signal Lights