Owner's manual before operating the unit, please read this manual throughly and retain it for future reference. Class d, sound quality, bass amplifier z-series.
Protect your investment note your information below for reference: model # serial # date purchased and: register your zapco product now at: www.Zapco.Com.
-2- mission statement committed to excellence zapco is dedicated to the pursuit of audio fidelity. Our prime objectives are to design and manufacture audio products of unsurpassed quality, to provide unparalleled support and service for these products, and to conduct business in a manner that will e...
Yes, please read this manual thoroughly. We wrote it to help ensure that you get the most from your investment in your zapco amplifier. If you find, after reading the manual, that you still have questions please feel free to give us a call at 1(800) 47-force, or, drop a note at power and wire gauge ...
Gain setting matching your components for best sound proper gain setting is one of the most important factors in setting up a stereo system. At the same time, gain setting is most often done wrong. Turning up the gain of an amp is the very last thing you should ever do to a system. An amplifier is a...
Digital class-d linkable mono block amplifier daisy-chain pass-through rca output dual mos-fet pwm power supplies stable into 1 ohm / 2 ohm parallel speaker connection 24 db variable low pass (lpf) crossover 12 db variable bass boost equalization 0 - 180 degree variable phase shift 24 db variable su...
Single amp rca connection z-1kd / z-2kd / z-3kd head unit wired remote control (optional) if no sound, please check the master/slave switch. The mode switch should be in master position, if in slave position the unit will not play master & slave rca connection z-1kd / z-2kd / z-3kd "master unit" "sl...
Z-1kd z-2kd / z-3kd first make the ground connection, then +12v wire connection, and finally the remote connection. Note: the +12v wire must always be fused at the battery for protection against possible damage. If you need to replace the power fuse, replace it with a fuse of the same value. It may ...
Gnd rem b+ spk b spk a speaker outputs power input gnd rem b+ spk b spk a speaker outputs power input please note that this unit is a mono block amp and only has one channel. Spk a and spk b are just labeled for clear illustration. Spk a and spk b are in a direct parallel connection inside the ampli...
Gnd rem b+ spk b spk a speaker outputs power input gnd rem b+ spk b spk a speaker outputs power input using a dual amplifier configuration, the master amplifier has total control over the slave amplifier. When using dual amplifier to operate subwoofer, the positive terminal of the subwoofer's voice ...
-10- rated power output -rms power, 2 ohm linkable/dual mono----------------------- -rms power, 1 ohm mono ------------------------------------ -rms power, 2 ohm mono ------------------------------------- -rms power, 4 ohm mono ------------------------------------ signal to noise ratio -------------...
Trouble shooting guide this power amplifier has protection features to prevent most forms of damage. If the unit senses excessive heat, short circuited speakers or overload, the protection indicators will be lit and the system will be turned off. Prior to checking the wiring for any fault, you shoul...
