Zartek ZA-180 User Manual - page 7
5.
.
.
.Power off
Press the Power button for 3 seconds and the device will switch off. If the device is turned
off during a video recording, the video file will be saved automatically first.
6. Auto-power off function
• If the battery power level gets low whilst recording, the video file will be saved
automatically and the device will switch off.
• If the memory capacity gets used up whilst recording, the video file will be saved
automatically and the device will switch off.
7.
.
.
.Connecting to a computer
• Plug the supplied USB cable into the device and the other side into the USB port on a
PC or laptop.
• The device can be connected whilst powered on or in standby mode. It is possible to
access the memory card to edit the folder, delete files, add files etc.
• To play video files, select the video and open using a media program. Not all files are
compatible on all programs as some codec may be needed.
• When the device is connected to the PC, the blue light will indicate battery charging
and the red light indicates that it is connected.
• If the computer does not recognize the device or card in 30 seconds, disconnect and
reinsert.
• Large video files should be copied onto the computer’s hard disk as playing directly
from the device may be slow or unsmooth.
8. PC Camera
• The PC camera can be used as a webcam on social media or to capture videos from
your computer.
• Install
the
driver
from
the
supplied
CD.
The
driver
name
is
SPCA1528_V2237_W…Setup.exe. Run this program and follow the prompts to install.
Once installation is complete an icon called AMCAP will appear on the desktop.
• Use the supplied USB cable to connect the camera to a computer. Press the MODE
button to switch into PC camera mode. Open the AMCAP program to use as PC
camera to capture videos and change settings.
• To stop the PC camera function, first close the AMCAP program and then remove the
device from the computer.
5