Zartek ZA-441 User Manual - Warning!
WARNING!
• Fully charge the worklight before storing for long periods. Keep recharging
every few months or the battery may go faulty.
• Do not recharge this worklight with any other adaptors other than those
supplied with the unit.
• Do not dispose of the worklight in a fire or ordinary waste.
• Do not operate the worklight in high temperature, hazardous or explosive
environments.
• Do not subject the worklight to strong impacts.
• Do not disassemble or modify the worklight as it contains protective
devices which, if damaged, may cause the battery to heat or ignite.
• Do not leave the worklight in direct sunlight or hot spaces for extended
periods.
• Never short circuit, reverse polarity, disassemble, damage or heat the
battery packs over 100°C. If an exploded Li-ion battery does ignite, it will
burn more violently if it comes into contact with water or moisture. Never
put water on a burning Li-ion battery only use a fire extinguisher.
• This worklight is rain and splash proof only but not submersible. If the
worklight gets submersed in water, immediately dry the worklight and do
not use for a few days. Water damage is usually irreparable.
Operation:
The on/off dimmer turn switch is located at the back of the unit. It is a linear
switch for adjusting the beam brightness from 1%
– 100%. Battery life will
depend on the brightness of the beam.
The Zartek ZA-441 worklight has an Aluminium lightweight housing for the light
with powder coated steel H stand for firm positioning on flat surfaces. Beam
direction can be adjusted by 360° horizontally and 90° vertically. Fix the worklight
head position by tightening the 3 hand screws.
•
Reflector for Uniform Light Dispersion
•
Colour Temperature 2700-7000K
•
Beam Angle 120 Degrees
•
Beam distance approx. 80 meters, Wide Area