Zaxcom TRXFB3 User Manual - page 32
Zaxcom TRXFB3 Specifications
32
Specifications
Transmitter
Power output: 25 / 50 / 100mW – Firmware Selectable
RF Modulation: Proprietary Digital Method
RF Frequency Range: TRXFB3.5: 512 - 614 MHz
TRXFB3.6: 596 -698 MHz
RF Frequency Step: 100 KHz
RF Bandwidth in ZHD 48 Mode: 50 KHz
RF Bandwidth in ZHD 96 Mode: 100 KHz
RF Bandwidth in XR Mode: 200 KHz
Channel Separation in ZHD 48 Mode: as close as 100 KHz (receiver dependent)
Channel Separation in ZHD 96 Mode: as close as 200 KHz (receiver dependent)
Channel Separation in XR Mode: 400 KHz
Antenna Connector: 50 Ω SMA Female
Emission Designator: 180 KV2E, 100 KV2E, 50 KV2E
FCC Part: 75.861
Transmitter Audio
A-D system: NeverClip Zaxcom proprietary
Input Range: -60 to -30 dBu
A-D Dynamic Range: 126dB (Stereo version 106 dB)
ADC Bit-Depth: 24 Bits
Analog distortion: 0.002%
Frequency Response: Mode 0: 20 Hz to 16 kHz / T & M Mode 0.2 Hz to 16 kHz
High Pass Filter: Off or 30 to 220 Hz, Steps: 10 (6 dB Per Octave)
Time code Reader/Generator
Clock Accuracy: 1.54PPM (1 Frame Out in 6 Hours)
Time code Type: SMPTE
Time code Frame Rates: 23.98, 24, 25, 29.97NDF, 29.97DF, 30NDF, 30DF
Recording
Media: Micro SD Card (Flash Memory)
File Format: .ZAX
Recording Time: Up to 216 Hours (16 GB card)
2.4 GHz ZaxNet IFB Receiver
RF Frequency Range: 2.403 to 2.475 GHz
RF Modulation: Digital Spread Spectrum
RF Frequency Step: 0.001 GHz (1 MHz)
RF Bandwidth: 1 MHz
Channel Separation: 2 MHz
Sensitivity: -96 dBm
DAC Bit-depth: 24 bit
DAC Rate: 48 kHz
Receiver Audio
System Group Delay: 10 ms
Dynamic Range: 96 dB
Distortion: 0.01%
Frequency Response: 60 Hz to 12 kHz
Output Connector: 1/8” Stereo (3.5 mm)
Compatible HP Impedance:32 to 200 ohms