ZBoost ALTE-AWS User Manual - Technical Specifications
zBOOST
®
SOHO DATABLAST USER GUIDE
10
zBOOST
®
SOHO DATABLAST USER GUIDE
11
At Initial Power Up Only
Solid GREEN
Normal condition at power up.
Slowly Alternating RED and GREEN
zBoost is working, but at reduced performance and
coverage due to “non-ideal” setup.
Solution: Increase the distance between antenna
and amplifier to achieve maximum performance and
coverage.
Fast Flashing RED
Indicates insufficient distance between the antenna and
the amplifier. The amplifier is operating at significantly
reduced coverage.
Solution: Increase space between base unit and
antenna.
Solid RED
System is receiving signals from either the mobile
device or the base station transceiver which are too
strong for proper operation.
Solutions:
Move away from receiving antenna with
your cell phone.
Move antenna away from other
devices..
Fast Alternating RED and GREEN
followed by no light
The amplifier is disabled.
Solution: Unplug your system and re-power.
After Initial Power Up
Solid GREEN
Normal condition
Solid RED
System is receiving signals from either the mobile
device or the base station transceiver which are too
strong for proper operation.
Solution: Unplug your system. Re-orient your Signal
Antenna and/or Base Unit to reduce the excessive
signal source. Plug your system back in. If still solid red,
call customer support 1-800-871-1612.
zBoost Base Unit Light Indicators
Technical Specifications
This product is covered by patent US 7,706,744. Other U.S. and
foreign patents pending.
Product Specifications for zBoost YX550 SOHO DataBlast Series
Specifications for VLTE
Band
Specifications for ALTE
Band
Specifications for AWS
Band
Frequency
Uplink: 776 to 787MHz
Downlink: 746 to 757MHz
Uplink: 704 to 716MHz
Downlink: 734 to 746MHz
Uplink: 1710 to 1755MHz
Downlink: 2110 to 2155MHz
Band supported
13
17
4
Networks
LTE (Verizon)
LTE (AT&T)
AWS
Output Power
+20dBm in UL and
+13dBm in DL
+20dBm in UL and
+13dBm in DL
+20dBm in UL and
+10dBm in DL
General Specifications for all zBoost DataBlast Models
System Gain
60dB
Power Consumption – Power Supply Current
3W standby; 7W max signal - 2.0A Max
Wall Supply Input ; Voltage
100-240VAC, 50-60 Hz; 5.0VDC
Input and Output Impedance
TNC Connector: 50ohm; F Connector:75 ohm
System Certifications
FCC Parts 15 & 27, Industry Canada
Base Unit Size and Weight
5” x 7” x 1.25” – 9 oz.
Operating Conditions
Indoor Use Only (40° - 105° F)
Coverage (open areas)
Up to 2500 square feet
This product uses patented technology to protect the carrier network