ZBoost ZB575X-A Manual - page 14
zBoost
®
TRIO Xtreme ZB575X Manual
7
no obstructions between the zBoost Base Unit and your mobile device.
Note:TheBaseUnitcanbeeasilymountedonawallbyfirstremovingtheSilverbracketfromthe
BaseUnit(see“zBoostBaseUnitAssembly”above)andusing2mountingscrewstoaffixtowall-
keeping the antenna vertical.
Remember, the zBoost TRIO requires at least 15 feet of vertical separation between the Base
UnitandtheExternalAntenna.Generally,increasingthisdistance(upto40feet)willincreasethe
performance and decreasing the distance will limit zBoost performance.
THIRD: Connect the coax cables via the provided window entry cable
NOTE: Refrain from securing cable or drilling holes until the system has been tested.
ThezBoostZB575Xincludes2coaxcables(35ft.and15ft.)andawindow-entrycablefor
connectingtheExternalAntennatotheBaseUnit.Ifyoudonotplantorunthecablethrougha
window, the window entry cable is not needed.
To run the coax cable through a window: Connect the two provided RG-6 cables (35 feet & 15
feet) using the provided window-entry cable. Use the attached cables to connect the Base Unit and
ExternalAntennathroughawindow,positioningthewindow-entrycableatthewindowclosing(See
Option 1 on page 8).
To run the coax cable through a wall: Connect the two provided RG-6 cables. Then connect one
endofthecabletothebaseoftheExternalAntenna.Runthecoaxialcablealongadescending
pipe or through a wall that leads closest to the location of the Base Unit. Connect the remaining end
of the cable to the Base Unit (See Option 2 on page 8).
Shouldyouneedadditionalcablelength,15footextensions(Part#:
YX030-15w) are available at
www.zBoost.com. Please note: Cable longer than 65 feet is not recommended.
FOURTH: Connect the zBoost Base Unit to Power
Connect the zBoost Base Unit to the power supply and plug into a power outlet.
Upon initial power up, the LED will cycle RED, GREEN and ORANGE for 30 seconds. After 30
seconds,aseriesofGREENflasheswillindicatethequalityofyoursetup.Followingthis,asolid
GREEN light indicates normal conditions. If it is not solid GREEN, follow the instructions in the
BaseUnitLEDIndicatorssection.Adjustmentsmaybeneededtooptimizeperformance.Ifyoufind
the increased signal coverage is acceptable, however, no additional adjustments are needed. See
“zBoost Base Unit Light Indicators” on page 11 for more information.
zBoost Base Unit
Power Supply
Indoor Antenna
Coaxial Cable
Base Unit Bracket
zBoost Base Unit Assembly