ZDC ZA-5000-D Quick Installation Manual - page 4
of
10
== CONFIDENTIAL (All right reserved by ZDC) ==
4
Connect the Ethernet
The
Access Point
supports 10/100M Ethernet connection. Attach UTP Ethernet cable to the RJ-45
connector on the
Access Point
. Then connect the other end of the RJ-45 cable to a hub or a station.
Put UTP cable through the water-joint
Make the RJ-45 connector:
white orange
̮orange white green̮blue white blue̮green white brown̮brown
Plug water-joint into the
Access Point
and
close the water-joint.
Notice
˖For protected build-in 23dBi gain antenna of wireless1, Surface of device
was placed plastic protective pellicle, when you use device, please rip away.