Zebex Alpha-50 series User manual - page 4

I M P O R T A N T   N O T I C E

Every effort is mode to ensure the accuracy

jof our product information; however, we

accept no responsibility for errors or

omissions.  Specification or version may

be subject to change without notice. The

actual specification and version are based

on the product delivered.

PRINTED IN MARCH 1999

T A B L E   O F   C O N T E N T S

Introduction

.........................................................1

Default Parameters

.............................................2

Program Procedure

.............................................5

System Setting

....................................................6

Scanning Mode Selection

....................................7

Header and Trailer

..............................................8

I

nter- Message Delay

..........................................8

Inter- Character Delay

.........................................9

Message/ Block Mode Selection

..........................9

Beeper Tone Selection

......................................10

Bar Code ID Selection

....................................... 11

RS-232C Serial Communication Parameters Setting

Handshaking Protocol

...............................13

ACK/ NAK Response Time Setting

............14

Baud Rate

.................................................15

Data Bit

.....................................................15

Stop Bit

.....................................................15

Parity Setting

............................................16

Message Terminator

..................................16

Break Code On/ Off Setting

.......................20

Keyboard Emulation Parameters Setting

............17

Keyboard Type Selection

...........................17

Language Selection

...................................19

Message Terminator

..................................20

Function Key Emulation

.............................21

Capital Lock Setting

..................................21

Reading Code Selection

....................................21

Code 39 Parametrs Setting

................................24

Interleaved 2 Of 5 Parameters Setting

................25

Chinese Post Code Parameters Setting

.............26

UPC/ EAN/ JAN Parameters Setting

..................26

Codabar/ Monarch Parameters Setting

..............30

Code 128 Parameters Setting

............................31

MATRIX 25 Parameters setting

..........................32

MSI/Plessy parameters setting

...........................32

i