Zebra HS2100 Quick Start Manual
Rugged Wired
Headset
Zebra reserves the right to make changes to any product
to improve reliability, function, or design. Zebra does not
assume any product liability arising out of, or in connection
with, the application or use of any product, circuit, or
application described herein. No license is granted, either
expressly or by implication, estoppel, or otherwise under
any patent right or patent, covering or relating to any
combination, system, apparatus, machine, material,
method, or process in which Zebra products might be
used. An implied license exists only for equipment,
circuits, and subsystems contained in Zebra products.
Zebra Technologies Corporation, Lincolnshire, IL USA
http://www.zebra.com
Zebra and the stylized Zebra head are trademarks of ZIH
Corp., registered in many jurisdictions worldwide. All other
trademarks are the property of their respective owners.
© 2016 Symbol Technologies LLC, a subsidiary of Zebra
Technologies Corporation. All rights reserved.
HS2100
Quick Start Guide
MN-002758-02 Revision A — September 2016
Features
Over-the-Head (OTH)
Behind-the-Neck (BTN)
Position the Boom
Do not rotate the boom beyond the stop point.
* Applies to OTH model. The BTN model has only
left side boom placement.
Connect the Audio Cable
Insert the audio cable into either the top or bottom
audio cable port, depending on right or left
placement of the boom.
Position the keyed cable edge with the audio cable
port slot.
Adjust the OTH Headband
The headband can be squeezed for a tighter fit to
the head and clicks as it is positioned into place.
When adjusting the headband,
• Position the ear pad in the center of the ear.
• Position the T-Bar above the ear, half way
between the top of the ear and the top of the
head.
Adjust the Microphone
Position the microphone icon so that it is facing
your mouth.
Adjust the Microphone
Boom
Place the microphone two finger’s width away from
the corner of your mouth, so it is slightly to one
side.
Mute the Microphone
Place the microphone boom in the upright position.
Clip onto Clothes
To ensure that the headset cable does not interfere
with movement, clip the cable to clothing, using the
provided clip.
Maintenance
Replace T-Bar
* Applies to OTH model.
Replace Headband
Disassemble the headset to replace the headband.
Replace Ear Pad
Firmly grip and pull the ear pad and inner casing.
Align and snap the new ear pad into position.
Replace Windscreen
NOTE
This guide applies to both the
OTH and BTN headband
models, unless otherwise
noted.
Adjustable
Headband
Microphone with Windscreen
Disassembly Knob
Flexible Microphone Boom
T-Bar
Foam Ear Pad
Audio
Cable
Port
Cover
Microphone with Windscreen
Flexible Microphone Boom
Disassembly Knob
Audio Cable
Port Cover
Headband
Left Placement
Foam Ear Pad
Right Side Boom
Placement
Left Side Boom
Placement
1
2
Microphone Icon
NOTE
The Mute on Boom feature is
dependent on device support.
1
2