Zebra QL 220 Plus Release Note - 10Z
Summary of Firmware Changes
10z
2
14587L-002
08/19/2008
• Netmanage: Made changes to apply network profile function
• Update to handle 2048 byte keys and to check for duplicate EAP identifier numbers
Instructions for using Secure FTP with mirror:
To use SFTP during mirror, use the SGD command ip.mirror.mode and set the parameter
value to sftp.
Issues Corrected
• ZPL: fixed ID Matrix barcode.
• Fixed line printing for receipts exceeding 161 inches
• Enhanced signal strength, roaming support, and power save responsiveness for the Zebra
value 802.11g radio.
Additional information regarding the improvements to the Zebra 802.11g radio:
This software release improves the internal signal strength reporting for the Zebra 802.11g
radio. These enhancements improve the printer’s operation in areas with weak signals. As a
result of these changes the printer should roam less frequently.
Additionally, changes to the radio’s power-save algorithm have been made which will also
result in improved performance. Note that the power-save behavior is affected by settings on
both the access point and the printer. In particular, it should be noted that access point settings
have a direct relationship on wireless device sleep periods.
10z
Release Date: 3 October 2007
This firmware release includes all features of previous base version
It is for use with the following printer models:
• QL 420 Plus (Q4C-XXXXXXXX-XX)
• QL 320 Plus (Q3C-XXXXXXXX-XX)
• QL 220 Plus (Q2C-XXXXXXXX-XX)
• RW 420 (R4A-XXXXXXXX-XX)
• RW 220 (R2A-XXXXXXXX-XX)
Note •
The parameter value can be either ftp or sftp, with the default being ftp.
Note •
This firmware does not run on the older QL (H8 based) series printers
(QXA-XXXXXXXX-XX or QXB-XXXXXXXX-XX).