Zebra SC2 User Manual - page 8
pg. 8
P1040985-001 Rev. D
Charger Operation
The following table lists the batteries approved for use with the Smart Charger 2.
UseofchargersnotapprovedbyZebraspecificallyforusewiththeZebraseriesofprinterswillvoid
thewarrantyandcouldcausedamagetotheprinterorthebatterypack.Zebraisnotresponsiblefor
anydamagetoequipmentcausedbytheimproperuseofunauthorizedequipment.
Description of Batteries Supported
Part Number
Smart Battery for QLn220/320
P1031365-025
Smart Battery for P4T, RW4-PS
AK18913-001
Battery for QL 220/QL 320/QL 220 Plus/QL 320 Plus
AT16004-1
Battery for QL 420/QL 420 Plus
AT16293-1
Battery for RW 220
AK18026-002
Battery for RW 420
AK17463-005
ConsultyourZebrasalesrepresentativeorthefactoryfortheappropriatefullpartnumber.
The SC2 Smart Charger
The Smart Charger 2 is an AC fast charger with a universal 100 to 240, 50-60 Hz. VAC input. This
charger is intended for charging the Lithium Ion (Li-ion) batteries pack that to be used in the Zebra
mobile printers.
The Smart charger will charge a battery pack as fast as its charge level will allow, and then
switch over to a maintenance charge to keep the charge at its maximum.
Charging Status Indicators
Plug the SC2 into the AC wall receptacle using the supplied power cable, and then insert the
battery into the charging bay. The Battery Charging Indicator LED will report the charge status as
per the following table.
DCPowerInput
Indicator
BatteryStatus
Present
Green
BatteryNotPresent
Present
Green
BattryPresent&FullyCharged
Present
Yellow
Charging
Present
Amber
Fault
Present
Off
PresentandBattery
Health=POOR