Touch computer quick start guide tc51 mn-002859-03.
2 tc51 touch computer no part of this publication may be reproduced or used in any form, or by any electrical or mechanical means, without permission in writing. This includes electronic or mechanical means, such as photocopying, recording, or information storage and retrieval systems. The material ...
Quick start guide 3 features installing a microsd card the microsd card slot provides secondary non-volatile storage. The slot is located under the battery pack. Refer to the documentation provided with the card for more information, and follow the manufacturer’s recommendations for use. Note all fe...
4 tc51 touch computer 1. Lift the access door. 2. Slide the microsd card holder to the unlock position. 3. Lift the microsd card holder. 4. Insert the microsd card into the card holder door ensuring that the card slides into the holding tabs on each side of the door. 5. Close the microsd card holder...
Quick start guide 5 installing the battery to install the battery: 1. Insert the battery, bottom first, into the battery compartment in the back of the tc51. 2. Press the battery down until it snaps into place. Charging the tc51 use one of the following accessories to charge the tc51 and/or spare ba...
6 tc51 touch computer charging the tc51 1. To charge the main battery, connect the charging accessory to the appropriate power source. 2. Insert the tc51 into a cradle or attach to a cable. The tc51 turns on and begins charging. The charging/notification led blinks amber while charging, then turns s...
Quick start guide 7 1-slot usb charging cradle 5-slot charge only cradle power led power led tc51 charging slot.
8 tc51 touch computer 4-slot charge only cradle with battery charger 5-slot ethernet cradle spare battery charging led power led spare battery slot tc51 charging slot 1000 led tc51 charging slot 100/100 led.
Quick start guide 9 4-slot battery charger rugged charge/usb cable spare battery charging leds (4) power led spare battery slot.
10 tc51 touch computer scanning to read a bar code, a scan-enabled application is required. The tc51 contains the datawedge application that allows the user to enable the imager, decode the bar code data and display the bar code content. 1. Ensure that an application is open on the tc51 and a text f...
Quick start guide 11 figure 3 pick list mode with multiple bar codes in aiming pattern 5. The data capture led lights green and a beep sounds, by default, to indicate the bar code was decoded successfully. 6. Release the scan button. 7. The bar code content data displays in the text field. Ergonomic...
Zebra technologies corporation 3 overlook point lincolnshire, illinois 60069 usa http://www.Zebra.Com © 2017 zih corp and/or its affiliates. All rights reserved. Zebra and the stylized zebra head are trademarks of zih corp, registered in many jurisdictions worldwide. All other trademarks are the pro...
