Zebra TLP 3844-Z User Manual - page 21
Manual is about: Zebra Technologies Printer User Manual
of
68
Auto Calibration
NOTE: If you are using pre-printed labels, pre-printed label backing, or
continuous media, see “Manual Calibration” on page 40.
An auto calibration is performed when the printer is turned on (if media is
loaded) or after a media error is cleared. When it is auto calibrating, the
printer sets the sensor levels for, and determines the length of, the label you
are using.
If the status light flashes red, refer to “Manual Calibration” on page 40.
980441-001 Rev. A
13