Zed-3 CO4 Quick Start Manual - page 2
Quick Start Guide, document 96-00509-08
Page 2 of 2
CO4 Analog Gateway
6.
Enter the IP address and port of the Zed-3 IP PBX. (e.g. 192.168.1.50:5060)
7.
Press the “Submit” button.
8.
Click Dialing Plan | Routing Table.
9.
In the Route Table, enter “IP x ROUTE FXO 1,2,3,4”.
10.
Add a second route in the routing table, “FXO Address>: IP address, 5060 is the port it uses for SIP, and 9000 is the extension for the auto attendant. 11. Press the “SUBMIT” button. 12. Click FXO Config | FXO 1. 13. Change Registration to “Off.” 14. Change Hotline to “On.” 15. Enter “9000” in the Hotline Number text entry field. 16. Change Dailtone to “Off.” 17. Click the “SUBMIT” button. 18. Repeat steps 11 to 17 for FXO 2, FXO3, and FXO 4. 19. Click Advanced Config | IP Config. 20. Change 2833 Payload Type to “101.” 21. Press the “SUBMIT” button. 22. Click System Tools | Reboot to reboot the system. 4 Configuring the SE30 After the setup, you need to make sure that your IP PBX is setup to receive calls from the CO4. The following is an example of how you would set up your SE30 to receive or make calls from the CO4: 1. Login to your SE30. 2. Access Provision | Trunk | IP trunk. 3. Enter a two digit number for Trunk ID. (e.g. 23). 4. Enter the IP address and port number of the CO4 in the Proxy Address and Outbound Proxy Address text entry field (e.g. 192.168.1.100:5060). 5. Press the “Add” button. 6. Access Provision | Route. 7. Create a new route. Enter “xxxx+”, or a digit pattern for which you want to use the FXO lines, in the “Digit Pattern” entry field and add the trunk you have just created to “Order.” 8. Press the “Add” button.