Zed Audio Draconia Instruction & Installation Manual - page 12
Specifications
Specification
Draconia
The Deuce
Gladius
Output Voltage (volts into 2 ohm) per channel
17.32
28.28
16.73
Output Voltage (volts into 4 ohms) per channel
17.32
28.28
16.73
Output Current (amps into 2 ohm) per channel
8.66
14.14
8.36
Output Current (amps into 4 ohms) per channel
4.33
7.07
4.18
Continuous Output Power into 2 ohm per channel
150wx2
400wx2
140wx4
Continuous Output Power into 4 ohm per channel
75wx2
200wx2
70wx4
Typical Output Power into 4 ohm per channel (0.8% THD)
95wx2 250wx2 85wx4
Continuous Output Power 2 channels bridged into 4 ohm
300wx1
800wx1
280wx2
Continuous Output Power 2 channels bridged into 8 ohm
150wx1
400wx1
140wx2
Minimum Speaker Impedance per channel
2 ohm
2 ohm
2 ohm
Minimum Speaker Impedance in Bridge Mode
4 ohm
4 ohm
4 ohm
Power Response at any power into 4 ohms/channel
10-100KHz -3dB
10-100KHz -3dB
10-100KHz -3dB
Frequency Response at rated power into 4 ohms/channel
10Hz-25KHz -0.1dB
10-25KHz -0.1dB
10-25KHz -0.1dB
Input Voltage range for rated power into 4 ohms
0.26-8 volt
0.26-8 volt
0.26-8 volt
Input Impedance
47K ohm
47K ohm
47K ohm
Noise below rated output (30KHz limited)
-98dB
-101dB
-98dB
Channel separation at 2KHz
>80dB
>80dB
>80dB
Damping Factor at 20Hz with 4 ohms
>180
>200
>180
Total Harmonic Distortion with 4 ohm 20Hz-20KHz
From 1 watt to rated power. Typically less than 0.05%
Intermodulation Distortion
Phase response at 20KHz
Lagging 10 deg
Lagging 10 deg
Lagging 10 deg
Slew rate (volts per micro second)-In”Flat” mode
15
15
15
Low Pass Crossover (all are 24dB/octave)
46Hz-3.5KHz
46Hz-3.5KHz
46Hz-3.5KHz
High Pass Crossover (all are 24dB/octave)
46Hz-3.5KHz
46Hz-3.5KHz
46Hz-3.5KHz
Equalization (Zero to +18dB variable control)
Bass Boost @44Hz
Bass Boost @44Hz
Bass Boost @44Hz
Remote Level Port with control
N/A
N/A
N/A
Line Output
Yes
Yes
Yes
Protection - Short Circuit, DC, Thermal
Yes
Yes
Yes
Power Source
----------------------10-14.5v DC Negative Ground ----------------------
Current Consumption with Sinewave at 4 ohms
20A
54A
40A
Current Consumption with Music at 4 ohms
6A
17A
12A
Idling Current
Fuse rating with 4 ohm load/channel
25A
60A
50A
Fuse rating with 2 ohm load/channel **** 35A 80A 70A
Size W x H (302.22mmx74mm/11.9”x2.91”) x L
314.4mm/12.4”
444mm/17.48”
444mm/17.48”
Shipping Weight (Kg/Lbs) 7.3/16 11.8/26 11.8/26
**** Under normal operating conditions the fuse rating for 4 ohm loads will suffice for 2 ohm loads. If the amplifier is driven for long periods of time into
2 ohm loads per channel the fuse rating may be increased as shown. DO NOT OVER FUSE ANY AMPLIFIER.
Page 9