Z-e3726 device installation manual en.
2 compatibility list ● the installation of the zenec system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incorrect installation can cause damage to the vehicle and the zenec system. ● correct functioning can only be guaranteed wh...
3 1 2.A 2.B 3 removal work and preparation: 1. Remove both storage compartments in accordance with the manufacturer‘s information. Installation: 2.A cut off the left and right plastic holders for the storage compartments as flush as possible. 3. Remove the two original torx screws at the top (t25). ...
4 5.A 4 5.B 5.A insert the mounting frame (no. 2) at an angle from above into the radio slot. 6. (no picture) fit the gps antenna (no. 6) at a suitable place, and make sure that the gps reception is not adversely affected due to shadowing by metallic vehicle parts (thermal glazing etc.). Use the met...
5 10 9 10. Connect all the cables to the zenec system (no. 1): those previously run in the radio slot, and the original antenna cable. If necessary, use the iso din antenna adapter (no. 8) included in the kit. Next slide the zenec system carefully into the radio slot until it is heard to engage. Com...
E c c d a a b b camer a reverse speed in ir in ext. Mi c power 300m a gn d audio in cvbs in cvbs in line in r line in l video in front out r front out l rear out r rear out l sub ( 4. 2 ) cnt ( 5. 1 ) ou t subwoofer ou t video out 1 video out 2 line out r line out l p. Cnt r parking reverse a/v in l...
