ZENEC ZE-MC190 Instruction Manual - page 71
70
71
ENGLISH
70
71
ENGLISH
6.. .Never.use.irregular.discs.
7.. .To.prevent.damage.to.the.mechanism.inside.this.unit,.avoid.impact.to.the.TFT.monitor.
8.. .Do. not. change. the. fuse. on. the. power. wire. without. professional. guidance.. Using. an.
improper.fuse.may.cause.damage.to.the.unit.and.result.in.a.fire.
9.. .The.monitor.employs.an.automatic.motorized.mechanism..To.prevent.damage.to.the.
core.mechanism,.please.do.not.push,.pull.or.swivel.the.monitor.manually.
DISCONNECTING THE BATTERY
To.prevent.a.short.circuit,.be.sure.to.turn.off.the.ignition.and.remove.the.negative.(-).battery.
cable.prior.to.installation.
NOTE:
If.the.unit.is.to.be.installed.in.a.car.equipped.with.an.on-board.drive.or.navigation.computer,.
do.not.disconnect.the.battery.cable..If.the.cable.is.disconnected,.the.computer.memory.
may.be.lost..Under.these.conditions,.use.extra.caution.during.installation.to.avoid.causing.
a.short.circuit.
NOTE:
It.is.especially.important.that.you.read.the.
WARNINGS.and.CAUTIONS.in.this.manual.