ZENEC ZEM-W652U Instruction Manual - page 15
15
Step
F
- Route the wiring through the
headrest
Run the supplied cable through the opening and
out the bottom of the headrest. If possible, con-
ceal the wires using a shaft covering. Connect
the +12V power, ground and video leads to test
the function of the monitor.
Step
G
- Insert the headrest bezel
Before connecting the monitor, pull the wire
harness through the mounting base of the head-
rest bezel as shown in diagram to the right.
Place the headrest bezel into the opening and
fix it with correct fasteners, scews, liquid nails or
hot melt glue.
Step
H
- Insert the monitor
Connect the monitor by plugging both system
wires together, and temporarily fit (do not fully
insert) the main monitor unit into the headrest
bezel opening.
Step
I
- Test and adjust the monitor
Turn on the unit and check the brightness,
headphone, volume control...... Finally, after
you have made sure all functions work as they
should, press the main monitor unit in place.
Removal of monitor
Insert Y plate between monitor and mounting
base to remove the monitor.
Release Key
ZEM-W652U Manual D+E.indd 15
24.09.2004 16:15:54 Uhr