ZENEC ZEM-W700RM Instruction Manual - page 4
4
DVD-Headunit
7” FLIP DOWN TFT MONITOR
6-pin
connector
To +/-12V
power supply (or car ignition)
black
red
In-line fuse
AV-
Interface
video
(yellow)
audio
(red)
+12V
GND
Switched lead
CONNECTION SCHEMATIC
CONNECTIONS / INPUTS & OUTPUTS
At the unit itself, there are three wires to be connected, to use the dome light function:
e
red wire: +12V
e
black wire: GND
e
White wire: To be connected to the switched lead of the vehicles internal lighting
A/V Interface (Black Box): The ZENEC ZEM-W700RM comes with an A/V interface
black-box, that features the following in- and ouputs:
e
Extension lead with 6-pin pc-plug for connection of the TFT monitor
e
A red* and a black power supply wire to be connected to the on board voltage of the
vehicle. The red wire with inline fuse holder should be connected to the ignition of the
vehicle, to avoid unnecessary current drain when the vehicle is not in use.
e
Two separate RCA output plugs (red and yellow), to connect a video source (DVD
headunit) and an audio source.
* the read power wire features an inline fuse holder – the correct fuse rating is 250V/2A –
only use the correct fuse rating or the monitor and the video electronics could be dama-
ged!
ZEM-W700RM Manual 11.09.2003 14:40 Uhr Seite 4