Zenesis ZN-302 A User Manual - page 20
3.2 User Programmable Options
* Once you enter into User Programmable Options, you will have 10 sec-
onds to enter a button press before it automatically exits.
ENTER INTO PROGRAMMING OPTION FIRST:
Press and release
3 times. Press and release
.
You will see 5 Blue LED flashes on the Remote Control. You
will also hear 5 beeps from the 2‐way Remote Control. You
are now in User Programmable Mode.
THEN FOLLOW THE CHART BELOW FOR PROGRAMMING OPTIONS:
Feature
Button
Combination
Options
Diesel warm
up time
→
30 sec
15 sec
7.5 sec
Siren sound
time
→
30 sec
70 sec
100 sec
Turbo timer
run time
→
1 min
2 min
5 min
Remote start
reservation
→
Automatic
Manual
Remote start
run time
→
15 min
5 min
25 min
Default values.
Confirmation
If programming for the feature is successful, you will see parking light flash(es)
and remote control BLUE LED flash(es) according to the last button being
pressed. You will also hear corresponding siren chirp(s) and remote control
beeps. Refer to bottom of Programming Guide on page 19.
Exit
If you are finished programming, wait 10 seconds for you to exit programming
mode. The Blue LED on the Remote Control will flash 5 times.
20