Zeniq dab+ 100 designed in denmark. Assembled in prc. Zeniq is a registered brand of nomenta industries (hk) ltd. . All rights reserved. Copyright 2013. Trademarks are the property of nomenta industries (hk) ltd. Or their respective owners unless indicated otherwise..
En disclaimer the information in this document is subject to change without notice. No liability shall be assumed for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the performance or use of this material. This document contain...
En table of content 1. Introduction ............................................................................ 2. In the package ....................................................................... 3. The 3 knobs .......................................................................... 4. The ...
Do not expose the radio to any heat sources or direct sunlight. Ensure proper ventilation around the unit at all times. Do not open or remove screws from the radio casing as this will void the limited warranty. If required, only qualified technicians are authorized to carry out repairs. Do not use t...
En 4. The back (1) left jack - headphones output (2) middle jack - dc (power in) (3) right jack - aux in or wireless receiver dc 5. Dab mode if this is the first time you turn on robio, the unit will automatically perform a full scan of all dab stations. You can perform a full scan at any time. 5-1 ...
En 5-3 drc dynamic range compression reduces the volume of loud sounds or amplifies quiet sounds by narrowing or compressing an audio signal's dynamic range. This can be used in noisy environments. Robio has 3 settings: drc off (drc is off) drc low (drc will compress 50%) drc high (drc will compress...
En 6. Fm mode turn the middle knob to its center position. Robio is now in fm mode. 6-1 quick tune to quick tune, simply short press the right knob. It will now find the nearest station with good signal (see “scan setting” for further instructions). By turning the right knob either clock or counter-...
En 6-5 scan setting under scan settings you can set the quick scan’s mode to “all stations” or “strong stations”. All stations = quick scan will stop at all stations even with a weak signal. Strong station = quick scan will only stop at stations with a strong signal strength. Press the right knob fo...
En 9. System settings 9-1 sleep function this function will automatically turn off robio after the selected time. Press the right knob for 2 seconds. Turn the knob to “system” and short press to confirm. Now turn the right knob to choose your time by confirming with a short press. 9-2 timer this fun...
En values are set by turning the right knob and confirming each step with a short press. 9-5 backlight settings here you can set the backlight levels to “timeout”, “on level” or “dim level”. Press the right knob for 2 seconds. Turn the knob to any one of the above and short press the right knob. Tim...
11. How to upgrade find out about product upgrades and accessories on www.Zeniq.Com 12. Warranty, service and repair if the product is damaged and needs repair, please contact us by phone or email, state the products serial number and describe your problem. See terms on the web at www.Zeniq.Com or c...
