Summary of CS-508/2300-MK
Page 1
Instruction manual gasoline chain saw cs-508/2300-mk.
Page 3
3 1. Intended use petrol chainsaw is intended for woodcutting, limb cutting and household logging. The saw is not intended for extended operation as vibration can cause disturbed blood circulation. The chainsaw should be used under the following conditions: • ambient temperature from -20°С to +40°С;...
Page 4
4 4. Product features guide bar -1; saw chain - 2; chain brake - 3, which stops the chain; front handle - 4; plastic body - 5, with engine inside; choke control knob - 6; ignition switch - 7; throttle trigger lockout - 8; throttle trigger - 9; rear handle - 10; oil tank cap -11; fuel tank cap - 12; ...
Page 5
5 6. Pay special attention when handling fuel. Move at least 3 m away from fueling site before starting engine. 7. Stop the engine before refilling fuel or oil. 8. Do not operate the chain saw near flammable materials indoors or outdoors. There is a risk of explosion or fire. 9. Before each use insp...
Page 6
6 on the rear handle, your left hand on the front handle and your thumbs and fingers encircling the handles. Firm grip can reduce danger of a kickback and keep control on the saw. • make sure working place is free from any obstacles. Top of the guide bar should not touch a tree or another solid obje...
Page 7
7 attention: always use fuel, which is mixed with oil. Otherwise the engine may be damaged. Strictly follow the designated fuel/oil ratio. Mix fuel with oil in a separate can before refueling the saw. Shake the can. For correct dosing of oil we recommend using a 10-20 ml medical syringe without need...
Page 8
8 • before starting the engine make sure the chain brake is released. • choke control knob has three positions: normal; warm engine; cold engine. • switch the ignition switch in «on» position. • switch the choke control knob in closed position. • press the fuel pump button 10 times. • press and hold...
Page 9
9 2. Saw the felling cut from the other side of the tree 3-5 cm above the edge of the notch. 3. Never saw completely through the trunk. Always leave a hinge. • the hinge guides the tree. If the trunk is completely cut through, you lose control over the felling direction. 4. Insert a wedge or a felli...
Page 10
10 № maintenance procedure period, operating hours 1. Check screws and nuts 20 2. Clean the spark plug and check the electrode gap 10 3. Change the spark plug 100 4. Clean the muffler spark arrester 20 5. Clean the air filter 20 6. Clean or change the fuel filter 20 7. Clean or change the oil filter...
Page 11
11 9. Transport and storage 1. Store the saw in a dry place between - 40°С and + 40°С, at a safe distance from sources of ignition. 2. Transport and storage conditions should eliminate the possibility of mechanic damage and influence of atmospheric fallout. 3. Store the saw out of the reach of child...
Page 12
12 4. Engine runs un- evenly. Incorrect gap in the spark plug. Clean, set the correct gap or replace the plug. 5. Engine emits lot of smoke. Incorrect carburetor adjustment. Adjust the carburetor in the service center. Inadequate fuel. Use the correct fuel mix- ture ratio 25/1. If it is impossible t...
Page 13
13.
Page 14
Demix llc head office: 14, shevchenko str., 3rd floor dnepropetrovsk, ukraine, 49044 tel./fax: +38 056 375-43-16 http://www.En.Zenit-profi.Com.