Instruction manual rotary hammer rh-1300
3 general safety precautions warning! When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury, including the following. Read all these instructions before operating this product and save these instructions. For safe...
4 17. Avoid unintentional starting. Do not carry a plugged in tool with a finger on the switch. Ensure switch is off when plugging in. 18. Use outdoor extension leads. When tool is used outdoors, use only extension cords intended for outdoor use. 19. Stay alert. Watch what you are doing. Use common ...
5 technical specifications model rh-1300 rated power 1300 w rated voltage 220-240 v rated frequency 50-60 hz max drilling diameter wood 40 mm steel 13 mm concrete 26 mm no load speed 1100 rpm impact rate 4200 spm impact energy 3,5 j standard accessories wrench 1 side handle 1 standard accessories ar...
6 when the work area is removed from the power source. Use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable. 4. Replacing the bit. Insert the bit into the chuck and fix it with the wrench or turn the upper part of the keyless chu...
7 when the drill bit touches an iron reinforcing rod, the bit will stop immediately and the rotary hammer will react to revolve. Therefore please grip the side handle and handle tightly as shown in fig. 8. 3. Rotation only this rotary hammer can be set to rotation only mode by pressing the push butt...
8 maintenance and inspection 1. Inspecting the drill bits. Since use of an abraded drill bits will cause motor malfunctioning and degraded efficiency, replace the drill bits with a new one or resharpening without delay when abrasion is noted. 2. Inspecting the mounting screws. Regularly inspect all ...
9.
10
11.
Demix llc head office: 14, shevchenko str., 3rd floor dnepropetrovsk, ukraine, 49044 tel./fax: +38 056 375-43-16 http://www.En.Zenit-profi.Com.
