Zenith 19LS4D Installation And Operating Manual - External Equipment Setup
EXTERNAL
EQ
UIPMENT
SETUP
17
HD RECEIVER SETUP
EXTERNAL EQUIPMENT SETUP
This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you
do receive digital signals from a digital set-top box or other digital external device, refer to the figure as shown
below.
■
To prevent the equipment damage, never plug in any power cords until you have finished connecting all equipment.
IDEO
AUDIO
(MONO)
S-VIDEO
RGB (PC) IN
AUDIO IN
(RGB/DVI)
AV IN
H/P
ANTENNA/CABLE IN
VIDEO
AUDIO
COMPONENT IN
Y
L
R
P
B
P
R
When connecting Component cable
1
2
1. How to connect
Connect the video outputs (Y, P
B
, P
R
) of the digital set
top box to the C
CO
OM
MPPO
ON
NEEN
NT
T IIN
N V
VIID
DEEO
O jacks on
the set. Match the jack colors
(Y = green, P
B
= blue, and P
R
= red).
Connect the audio output of the digital set-top box to
the C
CO
OM
MPPO
ON
NEEN
NT
T IIN
N A
AU
UD
DIIO
O jacks on the set.
2
1
2. How to use
■
Turn on the digital set-top box.
(Refer to the owner’s manual for the digital set-top box. operation)
■
Select C
Co
om
mp
po
onneenntt input source by using the IIN
NPPU
UT
T
button on the remote control.