Zenith DA-3630A Installation And Operating Manual - page 18
18
Operation with Radio
Presetting the radio stations
You can preset 30 stations for FM and AM. Before tun-
ing, make sure that you have tuned down the volume to
the minimum.
11
Press FUNCTION on the front panel repeatedly
or FM/AM on the remote control until the FM or
AM appears in the display window.
2
2
And then every time you press FM/AM, FM and
AM changes alternately.
3
3
Press and hold TUNING/SKIP
or
on the front panel for about two seconds until
the frequency indication starts to change, then
release.
Scanning stops when the DVD Receiver tunes in a
station. “TUNED” and “STEREO” (for stereo program)
appear in the display window.
Note
“TUNED” only appears when the signal is FM and
STEREO.
4
4
Press MEMORY.
A preset number will flash in the display window.
5
5
Press TUNING/SKIP
or
on the
front panel to select the preset number you
want.
6
6
Press MEMORY again.
The station is stored.
77
Repeat steps 3 to 6 to store other stations.
To tune in a station with a weak signal
Press TUNING/SKIP
or
repeatedly in
step 3 to tune in the station manually.
To clear all the memorized stations
Press and hold MEMORY for about three seconds and
“CLEAR ALL” is appeared in the display window and
then press MEMORY again, the stations are cleared.
Note
If all stations have already been entered, FULL mes-
sage will appear in the display window for a moment
and then a preset number will flash. To change the pre-
set number, follow the steps 5-6 as above.
Listening to the radio
Preset radio stations in the DVD receiver’s memory first
(see “Presetting radio stations” on the left side).
11
Press FM/AM until AM or FM appears in the dis-
play window.
The last received station is tuned in.
2
2
Press PRESET
/
repeatedly to select the
preset station you want.
Each time you press the button, the DVD receiver tunes in
one preset station at a time.
3
3
Adjust the volume by rotating VOLUME on the
front panel or by pressing VOLUME + or - on the
remote control repeatedly.
To turn off the radio
Press POWER to turn the DVD receiver off or select
another function mode (DVD/CD, VIDEO 1 or VIDEO 2).
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For manual tuning, press TUNING/SKIP
or
on the front panel repeatedly.
For automatic tuning, press and hold TUNING/SKIP
or
for about two seconds on the front
panel.
For your reference
If an FM program is noisy
Press MONO/ST. on the front panel so that
“STEREO” disappears in the display window. There
will be no stereo effect, but the reception will
improve. Press the button again to restore the stereo
effect.
To improve reception
Reorient the supplied antennas.