Zenith VN1ANTADIG Installation
HDTV
Designed For
Questions?, ¿Preguntas? 201.661.9944
©2010 AmerTac™
Saddle River Executive Centre
One Route 17 South
Saddle River, NJ 07458
www.amertac.com
Made in China/Fabriqué en Chine/Hecho en China
I10-0000-A
360° Omni-Directional
Digital Flat Design
TV Antenna
360° Design-No Need to Constantly Reposition
Wide band amplifier boosts signal strength for increased picture and sound quality
Receives local HD and Digital TV broadcast signals for free
Receives maximum 1080i or 720p programming when transmitted
Blue power indicator light
High gain, low noise, wide band amplifier
Receives horizontal and vertical signals
Auto gain control
Powered by AC adapter or USB cable (both included)
VN1ANTADIG
Zenith is a registered trademark of Zenith Electronics LLC and used under license.
Zenith est une marque de commerce déposée de Zenith Electronics LLC et utilisée sous licence.
Zenith es una marca registrada de Zenith Electronics LLC y se utiliza bajo licencia.
Installation
Connect to Analog TV
- Connect coaxial cable connector to TV’s RF input.
Connect to Digital TV
- Connect coaxial cable connector to digital receiver, then
connect the receiver to TV.
Connect to Computer
- Connect coaxial cable to dongle (not included). Connect antenna
to computer with USB cable (included). Plug dongle into computer.
Adjust Antenna
- Lay antenna flat to recieve multi-directional horizontal signals.
No adjustment is needed.
- Stand antenna up to recieve both horizontal and vertical signals.
Adjust direction for best reception of individual channels.
Note:
Do not use antenna during thunderstorms. Turn off power.
Turn off power when not in use.
If antenna is not receiving correctly, try placing in different position.
1
2
3
4
Frequency: VHF (160~230MHz) / UHF (470~860MHz)
Polarization: Multi-Direction
Output level: Max 96dBuV
Input Voltage: AC110~120V or AC220~240V
Working Voltage: DC6V/100mA
Connector: IEC-connector female