10-8 Video Digital Evidence Solutions 102sd User Manual - Dvr Installation
- 5 -
DVR Installation
The installation of the 10-8 Patrol Car video system breaks down to
some very simple steps. The basic connection for video and audio
are very similar to a VCR or DVD player. The one area that differs
from what you may have done in the past is the connections for the
alarm inputs .
You will need a 12v power source for the system. 10-8 video
includes a power distribution block for your convenience. It
simplifies the installation and makes for a cleaner install, since just
1 power and 1 ground will be needed. We recommend that the
power source be from switched power that is only hot when the
vehicle key is in the 'ON' position.
Digital Video Recorder Unit (DVR)
The first thing you will want to do is locate where you want to install
the DVR. The small size of the unit makes that much easier than
just a few short
years ago. Your
first choice should
be in your main
equipment console
if you have one. If
there is no room in
the console, the
next areas to
consider are on
either side of the
console, in the
dash or under the dash. Try to keep the unit in sight of the driver
where they will be able to use the I/R remote more easily. If
needed, the DVR ships with 2 small brackets for mounting. Connect
the red/black power connector to the back of the unit by inserting
into the square receptacle on the rear of the DVR. Insert until
locked. The Black lead needs to be connected to a chassis ground
and the Red lead will connect to 12v ‘ignition on’ power source.