10-8 Video Digital Evidence Solutions In-Car Video System Installation & User Manual - page 19
36
37
Hardware: Installation
GPS System
Themagnetbackingisverystrongformountingontheroof.Itcanalsobe
mountedinthevehicle,underthewindshield.
1
Mounttheantennae.
2
RoutethecablebacktotheDVRandattachtotheportlabeledGPS.
TheGPSreceiverwilldisplayyourvehiclespeedandcoordinatesatall
timeonthesystemmonitor.Inaddition,GPScoordinatesareimbedded
inallrecordingsmadeonthesystem.Duringplaybackonacomputer,the
usercanelecttodisplayamapshowtheactuallocationofthevehicleasthe
videoisplayed.
As long as the vehicle is in a location with a clear view of the sky
and GPS satellites, you will get a reading from the GPS receiver.
It can be mounted inside or outside of the vehicle.
The location of the camera should give the best view of the rear/
transport area of the vehicle.
If the vehicle has a cage, we suggest the camera be mounted
high as possible and to one side pointing across the rear area
to be viewed. If there is no cage, another choice would be high
in the center of the vehicle in the front and pointing rearward,
mounting just to the rear of the windshield.
IMPORTANT: The ball mount on the rear camera has been
attached at the factory. Do not attempt to tighten further. If
necessary to remove and re-attach, the ball mount should
be tightened only to the point where it stops in the bottom
of the camera.
Setting the GPS Speed Trigger
LocatetheGPSsettingsbygoingtoMenu>Vehicle>Speed.Theonly
optionyouwillwanttochangeisthespeedoption.Itispresetto80MPH.
Whenthevehicleistravellingatarategreaterthanthissetting,theDVRwill
begintorecordandrecordaslongasthevehicleisoverthisspeedsetting.
G-Force Sensor
TheG-ForcesensorisintegratedintotheDVRandconfiguredatthe
factory.
Rear Camera
The10-8rearcameraisatrueDay/Nitecamerawithautomaticinfrared
andB/Wfunctions.Italsofeaturesanintegratedmicrophonetocapture
soundsandconversationsintheinteriorofthevehicle.
Mountingoptionsforthiscamerawillvarygreatlyfromvehicletovehicle
andwilldependontypeofvehicleandifthereisareardividerinthe
vehicle.Thecameraissuppliedwithafullyarticulatinguniversalmount.
Oncealocationhasbeenfound,runthesuppliedcablefromthecamera
totheDVR.Thecablewilldifferfromthefrontcameraastherearethree(3)
connectionsoneachendinsteadoftwo(2).This3rdconnectionisforthe
builtinmicrophone.Connectthecabletothe‘Rear Cam’sectionattherear
oftheDVR.
After installation the G Sensor needs to be ‘zeroed’.
Do this by going to Menu > Vehicle > G Sensor.
Highlight ‘Adjust’ to zero out the sensor.