2easy DMR21/D16 Technical manual - page 5
2 EASY
CAMERA MODULE
Note: Key A and key B can not be seen on the panel,they are cryptic.
Normally, key A and key B are not active.
To activate the buttons,
just set the DIP6 to ON position
Attention: All settings will be canceled if the
Restore Factory Setting
is
activated. Include the modules setting, such as Proximity module,
Keypad module (even if the modules are not connected to
the
Camera Module)
When in standby mode, short out the
Exit Button Port(EB+,EB-),
then continuously toggle the DIP-6 switch for 4 times with a warning
sound of BP+, and the three Indicators will blink at the same time,
that means the
Restore Factory Setting is in progress; If the three
Indicators turn off with a warning sound of BP+,it means the
Restore
Factory Setting is finished
Please know that the DIP6 switch must be set to ON while the others
are set to OFF to carry on the following settings.
When the door station with
Camera Module in standby:
(1)Press Key A, the
Unlock indicator turns on with the warning sound
of BP+, BP;
(2)Press Key A again to set the
Unlocking Mode to Normally Open
or
Normally Closed. (Normally Open: the Status indicator blinks
ones
with the warning sound of BP+;
Normally Closed:the Status
indicator blinks twice with the warning sound of BP+, BP)
If
TFT Module is connected, the info will be displayed on screen
When the door station with
Camera Module in standby:
(1)Press Key A, the
Unlock indicator turns on with the warning sound
of BP+, BP;
(2)Press and hold Key B to enter the
Unlocking Time Delay Setting, a
warning sound of BP will be heard and the
Status indicator blinks
one time per second
The counting of
Unlocking Time is the times that Status indicator
blinks (the units is second). For example,the
Status indicator blinks
for four times,that means the unlocking time is 4 seconds
When the door station with
Camera Module in standby:
(1)Press and holld Key A for 3 seconds to enter the
Warning Tune
Option Mode, the Status indicator turns on and the current tune
will be
played
(2)Press Key A again to play next tune
(3)Press Key B to exit
When the door station with
Camera Module is standby:
(1)Press Key B to enter
Tune Volume Setting, the Talk indicator
turns on and plays the tune at current volume
(2)Press Key A to increase/decrease volume
(3)Press B to exit
If
TFT Module is connected, the current Volume will be displayed on
screen
(1)During conversation, press and hold Key B for 3 seconds to
enter the
Talk Volume Setting. The Talk indicator turns on with the
warning sound of BP+,BP
(2)Press Key A to increase/decrease volume
(3)Press Key B to exit
• Unlocking Mode Setting
• Unlocking Time Delay Setting
• Warning Tune Setting
• Tune Volume Setting
• Talk Volume Setting
Speaker
Camera lens
Night view LED
MIC
Invisible key A
Status indicator
Talk indicator
Unlock indicator
Invisible key B
MODULES
1. Parts and functions
2. Settings via touch button
3. Restore to factory setting
DMR21 Technical Manual
-5-