2gig Technologies Touch Screen Wireless Keypad Quick Manual - page 3
©2013 2GIG Technologies Inc. All Rights Reserved.
3
LEARNING/PAIRING THE KEYPAD WITH THE
CONTROL PANEL
1
Make sure that the Control Panel has power using the supplied AC
adapter and confirm that the adapter is connected.
WARNING:
A Control Panel without the 900 MHz Transceiver
installed cannot communicate with the TS1.
2
Make sure that the TS1 has power from the supplied AC transformer.
Connect the AC adapter to the TS1. Confirm that the wires are
connected using the correct polarity.
3
As the TS1 powers up, the following message is visible on the display.
4
From the Control Panel’s Installer Toolbox, select System
Configuration.
5
Select the Go To button.
6
To go to question 4, enter 04.
7
Select the RF Keypad number to assign to the TS1. Use the → arrow
to select the RF Keypad number (1‐4). After selecting the RF Keypad
number, press the ↓ arrow to start configuring the specific
parameters for the RF Keypad.
8
Press the → arrow or press the number 1 on the keypad toggle the
se ng on the first ques on to “used”. Press the ↓ arrow to con nue
configuring options.
9
Set the RF Keypad Equipment Code to 1059 by pressing the ↓ arrow
until “(1059) 2GIG‐TS1 wireless touchscreen keypad” appears. Press
the ↓ arrow to advance to the next op on.
10
Learn the TS1 into the Control Panel. A er pressing the ↓ arrow in
the previous step, the Learn button appears.
INITIATING THE PAIRING PROCESS
Initiate the pairing process at the Control Panel by pressing the Learn
button.
1
On the Control Panel press the Learn button.