3ality 3FLEX TS-5-Compact User Manual - page 13
TS-5 Compact BeamSplitter User Manual
Version 1.0 – September 2011
13
3.1.2 Specific Safety Instructions
1. In case of outdoor usage, make sure that it the TS-5-Compact BeamSplitter is not exposed to
moisture or rain. Use appropriate covers in case of moist or wet weather-conditions!
2. In order to prevent overheating, make sure that the device is properly vented, especially when used
under protective covers!
3. Use only certified power-supplies with an internal current-limiter (fuse or trip-switch). Set this limiter
to 6 Ampere max. Make sure that the voltage of your power-supply has a nominal voltage of 12VDC
with a tolerance of not more than -10% / +25% (10.8-15VDC)!
4. Ensure that the TS-5-Compact BeamSplitter is always secure on a table, or mounted safely on a
tripod, fluid-head, remote-head, Steadi-Cam etc. with sufficient load capacity!
5. Ensure that your connector of the power-supplyis always easily accessible!
6. Disconnect this “power in” connector before any assembly or service work!
Be highly attentive when reaching into the camera platform while
in use, to prevent injuries from (unpredictable) movement.
Do not grab under the Height/Pitch Unit at any time.
See picture below for motorized movement areas.
Figure 4.
Moving Parts
Height/Pitch unit moves vertically. (On right
camera platform only)
Camera platforms and angle toward and
away from each other when converging
Right Camera sled moves along rails to
increase or decrease inter-axial distance
Camera platforms angle toward and
away from each other when
converging.
Left camera sled moves along rails to
increase or decrease inter-axial
distance
LEFT
CAMERA
Or
REFLECTED
EYE
RIGHT
CAMERA