3ality 3FLEX TS-5-Compact User Manual - 5.2.3 Power Input
TS-5 Compact BeamSplitter User Manual
Version 1.0 – September 2011
23
5.2.3 Power Input
Voltage 12VDC
%
%
25
10
+
−
(10,8-15VDC)
XLR pin assignment 1. 0V / GND for electronics, internal
motors and power-output X6 at right
camera
2. 0V / GND for power-outputs X27 at
left camera
3. +12V for power-outputs X27 at left
camera
4. +12V for electronics, internal motors
and power-output X6 at right camera
Rear view on TS-4-S:
Current 2 x 6Amax, externally limited
Connector TS-4-S NEUTRIK XLR 4pin, male
ATTENTION: Use only power-supply or battery-pack, which is compliant with the regulations in
your country and make sure, that the current of your power-supply is internally
limited to 6Amax by means of fuses or circuit-breakers!
The usage of the following Y-cable is recommended:
Figure 12.
Recommended Y-Power Cable
5.2.4 Power Outputs
Voltage 12VDC
%
%
25
10
+
−
(10,8-15VDC)
XLR pin assignment 1. 0V / GND
2. n.c.
3. n.c.
4. +12V
View on TS-4-S:
Current Total current for all Power-outputs (OUT1, OUT2, OUT3) together: 6Amax
Connector TS-2-s NEUTRIK XLR 4pin, female
GND :1
GND :1
+12VDC :4
+12VDC :4
1: GND
4: +12VDC
2: GND
3: +12VDC
XLR 4pin male:
From Power-Supply
For Motors and Right Camera (X6)
XLR 4pin male:
From Power-Supply
For Left Camera (X27)
XLR 4pin female:
To TS-2-Studio
Stereo Camera Platform
Please use cable with at least 0,75mm² or AWG 18.
Please keep the cables as short as possible.
Do not exceed a length of 5 meters / 16 ft.
1
2
3
4
4
3
2
1