3Com 3C3FE574BT User Manual - page 19
Installation Using Point Enabler
15
No Networking Installed
This procedure assumes that you have not already installed Windows NT
networking on your notebook computer. If networking is installed, see
“Networking Already Installed” on page 16.
1 In the Control Panel, double-click Network.
2 When the system prompts: ”Windows NT Networking is not installed. Do you
want to install it now?”, click Yes. This opens the Network Setup Wizard.
If the Network Setup Wizard does not appear, refer to “Networking Already
Installed” on page 16.
3 Check Wired to the network and click Next.
4 When the system prompts to have setup start searching for a network adapter,
click Select from List.
5 Click Have Disk. Insert the LAN PC Card Installation CD (disk) in the CD-ROM drive
and click OK. Use the path d:\install\disks\574BT, where d: is your CD-ROM drive.
6 When the Select OEM Option window opens, select FE574 - 3Com 10/100 LAN PC
Card-Fast Ethernet and click OK.
7 The Network Adapters list shows a check mark next to the 3Com LAN card. Click
Next to continue.
8 In the Network Protocols list, place a check mark next to each network protocol
required for your site and click Next.
9 In the Network Services window, place a check mark in the box next to each
desired service. Unless you are following specific guidelines from your MIS
department, select the default settings.
10 Click Next to install the selected components.
11 When prompted, enter the path to the Windows NT installation files (for example,
D:\i386 on the NT CD) and click Continue. The window will appear again with the
fields blank.
12 Remove the NT CD and insert the LAN PC Card Installation CD in the CD-ROM
drive and click OK.
13 Specify the path d:\install\disks\574BT, where d: is your CD-ROM drive, and click
Continue.
14 In the 3Com LAN card dialog box, accept the default settings and click Continue.
Depending on your computer’s current settings, a TCP/IP setup windows may
appear. Select the options that are required for your site and continue.
15 When the window for enabling or disabling protocols opens, click Next.
16 When NT is ready to start the network, click Next to copy the network files.
17 Provide your computer name and workgroup or domain name when prompted.
18 When the system displays “Networking has been installed on your computer,”
click Finish.
19 When prompted to reboot the computer, remove the LAN card Installation CD
from the CD-ROM drive and click Yes.