1. DL manuals
  2. 3Com
  3. Network Hardware
  4. 3C421600A
  5. Installation Manual

3Com 3C421600A Installation Manual

Manual is about: SuperStack II Remote Access System

Summary of 3C421600A

  • Page 1

    Part no. 1.024.1911 rev 2.00 december, 1999 ® i/o m odule i nstallation g uide s uper s tack ii r emote a ccess s ystem 1500 this guide describes how to install v.34 (analog), isdn-bri or a combination of v.34 and isdn-bri modules into the ras 1500 base unit or ras 1500 expansion unit. It includes t...

  • Page 2

    2 i/o m odule i nstallation g uide s uper s tack ii r emote a ccess s ystem 1500 overview the i/o modules are inserted into the ras 1500 base unit or ras 1500 expansion unit. The ras 1500 and ras 1500 expansion provide remote-access services and terminal server functions, via analog and bri isdn con...

  • Page 3

    Installing and removing i/o modules 3 installing and removing i/o modules installing an i/o module you can install v.34 (analog), isdn-bri or a combination of v.34 and isdn-bri modules in the ras 1500 or ras 1500 expansion unit. Use the following steps to install an i/o module: caution: the modules ...

  • Page 4

    4 i/o m odule i nstallation g uide s uper s tack ii r emote a ccess s ystem 1500 removing an i/o module use the following steps to remove an i/o module: caution: the modules are not hot-swappable. Power off the unit before installing, removing, or exchanging the modules. Failure to do so could damag...

  • Page 5

    Powering the unit on or off 5 powering the unit on or off to power on the ras 1500 base unit or ras 1500 expansion unit: 1 connect the power cord to the ac power port of the unit. 2 plug the power cord into the ac power supply source. The unit starts up. To power off the ras 1500 or ras 1500 expansi...

  • Page 6

    6 i/o m odule i nstallation g uide s uper s tack ii r emote a ccess s ystem 1500 copyright © 1999, 3com corporation part no. 1.024.1911 rev 2.00