3Com 3CR17251-91 - Switch 5500G-EI Stackable Gigabit Ethernet Getting Started Manual - page 57
Manually Configuring IP Information
57
logged on correctly, the Switch name (e.g
<5500G-EI>) should be
displayed as shown in
Figure 23
.
Once you have logged in you will automatically be in User View.
Figure 23 User View Login
3 Enter the
system-view command and Enter.
To confirm that you are in the System View, the following should be
displayed:
[5500G-EI]
4 Enter
interface vlan 1 and Enter.
5 Enter the IP address and subnet mask for the Switch as follows:
ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm
and Enter
.
(where xxx.xxx.xxx.xxx is the IP address and mmm.mmm.mmm.mmmis
the subnet mask of the Switch)
6 Select the
quit command and enter the default gateway for the Switch:
ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the default gateway)
7 From the User View, enter the
save command to save the configuration
to your Switch as the configuration is not saved automatically when the
Switch is powered down.
The initial set up of your Switch is now complete and the Switch is ready
for you to set up your chosen management method. See
“Methods of
Managing a Switch”
on
page 50
.