1. DL manuals
  2. 3Com
  3. Wireless Access Point
  4. 3CRWX275075A - Wireless LAN Managed Access Point 2750
  5. Quick Start Manual

3Com 3CRWX275075A - Wireless LAN Managed Access Point 2750 Quick Start Manual

Other manuals for 3CRWX275075A - Wireless LAN Managed Access Point 2750: Quick Start Manual
Manual is about: AP2750 Managed Access Point

Summary of 3CRWX275075A - Wireless LAN Managed Access Point 2750

  • Page 1

    Quick start guide ap2750 managed access point 3crwx275075a the 3com ap2750 managed access point provides ieee 802.11a or 802.11b/g wireless access to the network. The access point is designed for use with a 3com wireless lan switch, and requires hardware installation only. All configuration for the ...

  • Page 2

    2 3com ap2750 managed access point features feature description power port the access point can be powered either via power over ethernet (poe), or by an external power supply (not included) that is plugged into the power port. Serial port the serial port is not supported. Ethernet port the ethernet...

  • Page 3

    3 observing safety precautions this equipment must be installed in compliance with local and national building codes, regulatory restrictions, and fcc rules. For the safety of people and equipment, only professional network personnel should install the access point. 1 unpacking the access point make...

  • Page 4

    4 3 attaching the antennas carefully unpack the standard detachable antennas. Screw the antennas on to the antenna connectors on the access point and hand-tighten them. After network startup, you may need to adjust the antennas to fine-tune coverage in your area. For best results, adjust the antenna...

  • Page 5

    5 the figures below show the mounting bracket being mounted to a wall, and then a cable being routed through the large opening on the back of the mounting bracket. 4 connect the ethernet cable (and power cable, if applicable) to the port(s) on the front of the access point. 5 snap the access point o...

  • Page 6

    6 tabletop mounting to install the access point on a flat surface such as a table or desktop: 1 remove the backing from the four rubber feet and attach them on the bottom of the mounting bracket that is attached to the access point. 2 place the access point on the table. 3 connect the ethernet cable...

  • Page 7

    7 6 checking the led indicators when the access point is connected to power, leds indicate activity as follows (solid led indicates connection; blinking led indicates activity): troubleshooting refer to the mobility system configuration guide or to the 3com wireless lan switch reference manual to ob...

  • Page 8

    8 regulatory information general statements the 3com ap2750 managed access point (3crwx275075a) must be installed and used in strict accordance with the manufacturer's instructions as described in the user documentation that comes with the product. This product contains encryption. It is unlawful to...

  • Page 9

    9 the interference handbook this booklet is available from the u.S. Government printing office, washington, d.C. 20402. Stock no. 004-000-0034504. 3com is not responsible for any radio or television interference caused by unauthorized modification of the devices included with this 3com ap2750 manage...

  • Page 10

    10 to reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (eirp) is not more than that required for successful communication. To prevent radio interference to the licensed service, this device is inten...

  • Page 11

    11 english hereby, 3com corporation, declares that this rlan device is in compliance with the essential requirements and other relevant provisions of directive 1999/5/ec. Finnish 3com corporation vakuuttaa täten että rlan device tyyppinen laite on direktiivin 1999/5/ey oleellisten vaatimusten ja sit...

  • Page 12

    12 a copy of the signed declaration of conformity can be downloaded from the product support web page for the 3com ap2750 managed access point (3crwx275075a) at http://www.3com.Com. Also available at http://support.3com.Com/doc/ap2750_eu_doc.Pdf. Eu - restrictions for use in the 2.4ghz band this dev...

  • Page 13

    13 • in italy the end-user must apply for a license from the national spectrum authority to operate this device outdoors. • to remain in conformance with european spectrum usage laws for wireless lan operation, the above 5ghz channel limitations apply. The user should check the current channel of op...