3Com 3CWXMUPA Release Note - page 6
6
W
IRELESS
LAN S
WITCH
M
ANAGER
(3WXM) V
ERSION
3.0 R
ELEASE
N
OTES
There is no current workaround. If you perform an
“Undo” in this situation, you will undo the last sup-
ported action, instead.
3WXM incorrectly reports Mobility Domain
configuration changes after deleting and
re-uploading a WX switch. (16044)
If you delete a WX switch and re-upload the same
switch, Review Local Changes erroneously reports
that the seed and member switches need to be
deployed. This may be confusing as the configuration
to be deployed is identical to the current configura-
tion.
No action is required. Deploy the indicated configura-
tions to the WX switches.
3WXM reports that changes have occurred even
when the changes cancel each other out, but does
not list the changes. (16212)
If you make a configuration change to a WX switch
and then reverse the change before synchronizing
3WXM and the WX, 3WXM still reports that changes
have occurred, but does not list any changes. For
example, if you use the CLI to change the system
description, then clear the change, the Local & Net-
work Changes dialog shows Configuration changes
in the Local Status field for the WX. However, no
changes are listed when you select Review.
This issue is cosmetic and does not affect the configu-
ration or operation of 3WXM or the switches.
Domain Policy manager does not correctly identify
changes. (16383,16384,17692)
The Domain Policy manager does not list some
changes, such as changes to the order of network
access rules. Generally, changes are not listed if there
is no valid CLI to generate for the configured values.
For example, if you configure an 802.1X network
access rule but you do not specify a RADIUS server
group, this is an invalid configuration and cannot be
mapped to a valid CLI command.
3WXM does not support the Ctrl + drag-and-drop
mouse operation. (16425)
Polling interval for client session cannot be changed.
(17585)
By default, 3WXM polls every 10 seconds for updates
to information for clients on the watch list. In Version
3.0, this polling interval cannot be modified.
Enabling STP on an WX switch's management VLAN
causes a configuration deployment to fail. (17668)
If you use 3WXM to enable STP on an WX switch's
management VLAN, then deploy the configuration,
the deploy fails. The failure occurs because the man-
agement interface must pass through the standard
Listening and Learning states, which together take at
least 30 seconds, before the interface can change to
the Forwarding state. Until the interface reaches the
Forwarding state, the switch cannot receive traffic,
such as configuration deployment from 3WXM, on its
management interface.