3Com Router 3030 Release Note

Manual is about: 3Com 3012: Reference Guide

Summary of Router 3030

  • Page 1

    Http://www.3com.Com/ router 6000 and 3000 dsl family release notes software v 2.01 router 6040 (3c13840) router 6080 (3c13880) router 3030 (3c13630) router 3031 (3c13631) router 3032 (3c13632) router 3033 (3c13633) router 3034 (3c13634) router 3035 (3c13635) part no. 10014363 published august 2004.

  • Page 3: Outer

    1 3c om r outer 6000/3000 dsl f amily r elease n otes software v 2.01 introduction these release notes address the following: ■ v2.0 to v 2.01 software upgrade ■ hardware accessories installation ■ system access ■ snmp ■ system management ■ interface management ■ link layer protocol ■ network protoc...

  • Page 4

    2 c hapter 1: 3c om r outer 6000/3000 dsl f amily r elease n otes s oftware v 2.01 incorrect packet received it is necessary to wait 3 minutes and then repeat the command. Important: for 3com 6000 router family running v2.00 router software. If you upgrade your router software via tftp and set the d...

  • Page 5

    System management 3 system management ■ the display pvc command from user view is not supported. ■ the system clock on the router 6000 may reset after reboot. The system clock on the router 3000 dsl family resets after reboot. Configure ntp protocol or check system clock and set clock manually. ■ ca...

  • Page 6

    4 c hapter 1: 3c om r outer 6000/3000 dsl f amily r elease n otes s oftware v 2.01 ■ a router running dhcp client cannot obtain the default gateway address. Auto configuring the default gateway is not supported in this release. You must manually configure this setting. ■ you cannot access certain we...

  • Page 7

    Mpls 5 ■ frame relay congestion control becn/fecn does not function. Disable ip fast forwarding on the interface if frame relay traffic shaping is selected. ■ frame relay traffic shaping is inactive on interfaces that use frame relay traffic shaping. Disable ip fast forwarding on the interface if fr...

  • Page 8

    6 c hapter 1: 3c om r outer 6000/3000 dsl f amily r elease n otes s oftware v 2.01 ■ the snmp trap enable default is incorrectly documented. All traps are enabled when the snmp-agent command is executed ■ firewall aspf udp detection does not support the following udp based applications: tftp, ssh, d...