1. DL manuals
  2. 3Com
  3. Switch
  4. SUPERSTACK II HUB 10 MANAGEMENT MODULE
  5. User Manual

3Com SUPERSTACK II HUB 10 MANAGEMENT MODULE User Manual

Other manuals for SUPERSTACK II HUB 10 MANAGEMENT MODULE: User Manual
Manual is about: Network Supervisor

Summary of SUPERSTACK II HUB 10 MANAGEMENT MODULE

  • Page 1

    Related standards the hub 10 telco has been designed to conform to the following standards: physical electrical hub 10 telco only hub 10 telco & management module environmental t echnical i nformation functional iso 8802/3, ieee 802.3 safety ul 1950, en 60950, csa 22.2 #950 emc en 55022 class b, en ...

  • Page 2: Afety

    Please read the following safety information carefully before installing the hub 10 telco. Warning: installation and removal of the unit must be carried out by qualified personnel only . ■ connect the unit to an earthed power supply to ensure compliance with safety standards. ■ it is essential that ...

  • Page 3: Ntroduction

    The superstack™ ii hub 10 telco (3c16672a) has two 12 port telco connectors on the front panel providing ethernet tp port connections, and an aui port on the rear panel. The rear panel also has a slot for a 3com transceiver module or bridge micromodule: if fitted the module will operate in addition ...

  • Page 4: III

    Front panel 1 24 telco ports a range of telco connectors can be used with the hub 10 telco. Refer to “ introduction ” for more information. Caution: do not over-tighten the screws on the telco connectors. 2 mdi switch the media dependent interface (mdi) switch controls the operation of port 24. The ...

  • Page 5

    Rear panel connection 11 power supply and fuse warning: ensure that the power supply is disconnected before opening the fuse holder cover. The hub 10 telco automatically adjusts to the supply voltage. The fuse is suitable for both 110v a.C. And 220-240v a.C. Operation. To change the fuse, release th...

  • Page 6

    Siting the hub 10 telco caution: when installing the hub 10 telco in a stack with fms units, the hub 10 telco must be installed beneath any fms units. When deciding where to site the hub 10 telco ensure: ■ it is accessible and cables can be connected easily. ■ cabling is away from: ■ sources of elec...

  • Page 7: Roducts

    Products superstack ii hub 10 is part of the superstack ii range of 3com products. Contact your supplier for the latest product information. Hub 10 hubs 3c16670a superstack ii hub 10 12port tp 3c16671a superstack ii hub 10 24port tp 3c16672a superstack ii hub 10 24port telco 3c16665a superstack ii h...

  • Page 8: Imited

    For first five years - +5 lifetime limited warranty the superstack ii hub 10 fiber benefits from 3com’s enhanced +5 lifetime limited warranty. This provides a full 5 years of advanced hardware exchange from your date of purchase in accordance with 3com’s standard terms and conditions. To qualify, yo...